A step by step side on how to install the car floor mat clips.
Пікірлер: 47
@BigCheese853 жыл бұрын
Just fitted mine. So snug they are never going to move. The nail really works. I laid out the mat, marked a dot in the centre of the hole and then inserted the pin about 5MM behind that mark and it slotted in perfectly to where I wanted my mat.
@AndyBurtonUK8 жыл бұрын
A 32mm holesaw made very light work of making the perfect sized hole in the matt for the rings to fit. I marked the carpet underneath where the matt was going at the back of where the hole is, and this served as the perfect location to spike in the clip so that it lined up after it had been pushed forward into the carpet.
@charleshanson604610 жыл бұрын
Video is quite good but misses off the most important thing. Fitting the pin clip into the undercarpet. The pin is offset and it is not clear how to position the pin clips that are offset from the base in relation to the top carpet.. close but no cigar !!!!
@jboomadmill4 жыл бұрын
Great video and great product.
@AbuTawfiq6 жыл бұрын
Your video was very helpful thanks mate
@argocity096 жыл бұрын
Great thanks :-)
@amanjk65356 жыл бұрын
easy to install, great price. it fit my car
@lauwe547 жыл бұрын
nice and neat thanks for sharing
@nishadevi32936 жыл бұрын
Yes,if you wanna get a perfect and easy install car floor mats,
@Grahams-Grass5 жыл бұрын
Use a £2 coin to make a hole draw round makes them fit perfect
@robinbanks1835 жыл бұрын
Great tip there mate ***********
@irfankhanm61886 жыл бұрын
perfect snug fit for my car, and the raised edges are high enough to prevent melting snow and muds
@mohitvaram90176 жыл бұрын
attractive protection, and a very good investment!
@ddub59607 жыл бұрын
hi.how much for honda mat fixings,as my drivers mat moves all over the place.thanks 2010 se
@paulhewett6175 Жыл бұрын
How do you take the clips off to realign slots with studs in carpet please
@Grahams-Grass5 жыл бұрын
DONT WASTE YOUR MONEY. If you have a lot of traffic though your car the pins slide out as there is no barbs to hold them in place. The best way is lift your carpet up and install underneath. . The clips are good .but the pins need barbs to stop them sliding in and out I have tried fitting them every which way I can they will come out. I'm a taxi driver so mine get used and they have been sliding out. Finally one of the pins snapped . So I lifted the carpet up and put a little slit and popped the clip in for underneath . No more popping out .. it's how car manufacturers fit them as standard from under the carpet.
@irfqn30996 жыл бұрын
perfectly!*
@javedkhan-uy9sn6 жыл бұрын
The floor mat make my interior looks like a new car again,
@FastNFurious7 жыл бұрын
But how do you attach h it to the floor in the car? Do I need to make a hole in my cars floor as well?
@davidcooper67047 жыл бұрын
You cannot be serious. The answer, if you are serious is NO.
@jaredvillhelm20027 жыл бұрын
David Cooper 😂
@oneman28646 жыл бұрын
Ignore the sarcastic replys FastN Furious but David is right. It can be confusing at first. Watch this clip at 1.03 mins and beyond then imagine using only the base carpet (not two). I think you will get it. kzfaq.info/get/bejne/fL9-iLlkpquocY0.html
@edwardmoody42535 жыл бұрын
the needle part slides in the carpet
@SpacedOdyssey2 жыл бұрын
am yo from Tipton or Walsall
@dannyblondu2310 жыл бұрын
thenks
@kushal88226 жыл бұрын
makes it easier to clean.*
@ANGELUS55488 жыл бұрын
God damn where can you buy these clips from I just purchased mats today from car mats company online they are tailored to my car but they didn't include clips I have Toyota Yaris 2007 can't find them anywhere
I just bought a set of car mats without instructions. How the actual fuck do I get those bastard clips off so I can place the mats and then screw them back in? This shite is so much more complicated than it needs to be
@gynta3336 жыл бұрын
I disliked this video because he missed the most confusing procedure of how to fit the metal pin into the undercarpet. The metal pin arrives bent at 90 degrees angle and there is no gap between the metal pin and plastic clip housing, so undercarpet doesn't fit in between. I had to unbent the metal pin a little bit and make about 110 degrees angle. After that there was a little gap for the undercarpet to fit between the metal pin and plastic clip housing.
@argocity096 жыл бұрын
Sorry you did not feel this helped you enough, please get in touch as more than happy to help you where we can :-)
@CursedWheelieBin5 жыл бұрын
That sounds important but I don't understand it even slightly. I just bought a set of car mats and can't get the fuckers screwed in because the mats have these clips on them that won't budge
@gavinwakeford64943 жыл бұрын
The video might be good quality but the clips are absolute rubbish I was assured that fit my van what a waste of money