Maximize Your Mitersaw's Capacity

Maximize Your Mitersaw's Capacity - WOOD magazine

Рет қаралды 22,114

2 жыл бұрын

Does your mitersaw come up short when cutting through wide stock? Jim shows you a simple trick that increases your mitersaw’s capacity so you can finish the cut.
#woodworking #woodmagazine #mitersaw #DIY #powertool
Subscribe to the WOOD KZfaq channel: kzfaq.info_...
Subscribe to WOOD magazine: www.woodmagazine.com/subscribe
Get digital issues for iPad, Kindle, and more: www.woodmagazine.com/digital
Official website: www.woodmagazine.com
Shop for woodworking project plans at: www.woodstore.net?a=youtube
Read tool reviews from WOOD editors and other real woodworkers at: www.woodmagazine.com/review
Facebook / woodmagazine
Twitter / wood_magazine
Pinterest / woodmagazine

Пікірлер: 18

@G.I.JeffsWorkbench 2 ай бұрын

Excellent solution for those of use who have smaller miter saws, and especially for older, non-sliding “chop” saws. Thanks for sharing.

@gideonnel2654 2 жыл бұрын

Never to old to learn something!

@tree_carcass_mangler 2 жыл бұрын

Good tip. Thanks for posting - thumbs up.

@rpaasse6453 2 жыл бұрын

How simpel!! And why didn't i think of that. Thank you!

@americannumber2 2 жыл бұрын

That's a good and expensive piece of scrabe wood

@n8sot 2 жыл бұрын

Thanks!!!!!!!!

@tinkmarshino 2 жыл бұрын

I usually just pick up the outside edge a bit to finish the cut.. But this is a good idea for them long board.. thanks

@norm5785 2 жыл бұрын

Yes

@geostanley409 2 жыл бұрын

👍🏻👍🏻

@bpatriquin123 2 жыл бұрын

Great idea if you have a sliding miter saw… I have an older miter saw that doesn’t slide though. If I raised a piece of 2 by up that high, it’d rub up against the arbor nut

@Birdlab 2 жыл бұрын

Same here

@johnslaughter5475 2 жыл бұрын

What I did was, once the saw was down as far as it would go, I'd tip up the forward edge of the piece I was cutting. You need to make sure you keep it straight. I would never try it when cutting at an angle. I recently bought a 10" sliding miter saw and am very happy with it.

@bpatriquin123 2 жыл бұрын

@@johnslaughter5475 that’s 1 way to do it I guess… I normally just clamp a scrap piece of wood to the fence of the saw and flip the piece I’m cutting 180°

@johnslaughter5475 2 жыл бұрын

@@bpatriquin123 Yes, a stop block will work quite well.