mad props bro. 2009 mazda 3 2.3l p0772. ordered kit and replaced per your video...all fixed. Thanks man!

Thanks friend for your video

I think I found my fix today..thanks

Hi Raul! Great video! I have a Mazda 3 2004 2.0L with about 76000km giving me the same problem. The AT light comes up and then it doesn't shift into the 4th gear. Downshifting is also VERY erratic when it comes on. I ran the codes and it pulled up a P0773 (Shift Solenoid 'E' Electrical). I had it checked by an 'expert' who changed the oil and filter but the problem persists (our technicians here basically don't know what they're doing). I want to get the repair kit like yours and have him change it. Hopefully that works.

Drian the oil when warm will help rather than cold .....depending on where you live.

Hello im having the same issue with solenoid c i put a new tcm and it remove 4 codes but its leaving me p0762 im not sure if solenoid needs to be programmed .

Muy interesante vídeo, en este tipo de transmisión cual de los selenoides a, c, b, maneja tcc, muy agradecido saludos

hi, What is the fault of Mazda 2 hatchback demio model 2004 when the error code shows P0733? is it possible the shift solenoid ? or low fluid? cause i check my transmission fluid on dipstick the other side shows 20% low & the other side is high? thats mean low fluid? When i put on gear D sometimes its can move forward sometimes not Even the reverse sometimes it can be reverse sometimes not .. I dont know where & how to check the tcm..

Hii i have a question i have code p0773 and p0768 i have a 2009 mazda 5 2.3L, i need to know exactly wich solenoid is wich because i seen they change numbers its confusing for me can you tell me wich solenoid is wich, i need change D and E

Also drip some fluid on the new O rings before installing so they Slide in ...

Idk if you still check these messages but here goes nothing: We are having transmission problems with our Mazda 3 2010 hatchback. Car will not engage in Reverse, 3rd, 4th, 5th. When we switch the shift stick to the manual tap shift, we can see it change to those gears but the car revs and does not engage the gear. We had this problem sporadically about 8 months ago, but it went away without changing anything. For the last week we haven’t been able to use those gears once. We have service code P0773. Already tried changing fluid, filter, and cleaning electrical sensors/plugs. Replaced input and output sensors as well, didn’t help. I am considering replacing the shift solenoid E, but we took it to two shops who said the transmission needs to be replaced (they did not open the transmission or do any thorough inspection, they just took a glance at the code and symptoms and said in their experience the transmission is done for). Personally, I don’t see how the transmission could be shot if we had this issue temporarily before but it went away. It seems electrical to me. Wdyt?

I have a code “P0766 shift solenoid D performance or stuck off”, i haven’t had any noticeable transmission problems, but i do have a trans leak which i pay close attention to. Is solenoid D the solenoid to the right of the one you replaced in this video? Thanks

Thanks for sharing the video. Cool. I have a Mazda5 2009 and the DTC code says P0753 - Shift Solenoid A Electrical. How would I know which one is for solenoid A in my case? How did you find out that solenoid is E in your case?. Thanks in advance. Appreciate.

Hello, how did those selenoids come out?

How about the solenoid B electrical,where it is??

Hey man, now that we are 7 months later, is your fix still working? How’s it running/shifting?

Nice video it helped me a lot. I have a mazda3 2008 2.0L I had a code p0766 (solenoid d) I changed every solenoid using your video for guidance. I replaced the filter, gasket and fluid as well. I turned off the check engine light with my obd2 scanner. I turned the car on and I was able to switch gears with no problems as to before It would jerk in R and D. I drove out the driveway and the car slipped into 3rd gear and check engine light and at light popped back on acceleration was slow. Any help please

Are you sure thats solenoid e? I seen 3 of the same ones, then 2 same ones and then there is just 1 solenoid that its different from the others

Que tal amigo buen video gracias tengo un Mazda 5 2006 la velocidad # 1y 2 no funciona que podría ser ? No le encuentro el módulo tcm espero me puedas ayudar si no es molestia gracias

I have a mazda 3 2005 2.0L. The car is not shifting to 4th gear and first i got a AT light over night and the car was acting wierd and i drive it back home from work the engine light showed up. Its not shifting to 4 th gear and the codes were : P0766, P0766Pd, P0771 Pd

P0753 ya cambie el selenoide A. Pero sigue encendido al AT y check Engine. Solo cambia hasta la 3 velocidad.

I need solenoid A for a 2007 2.3 hatchback where would I be able to find the kit

Hey man my mazda5 2008 with no code. After few miles drive D got stuck and jerking need to shift semi auto then goes run while In P position. Newly replace tcm. Any advice

i have mazda 323 familia 1997 model gen 2. i have this kind of issue that when my car shifts to 2nd it jerks. and when in 3rd it hesitates a bit. so i suspected it in shift solenoid. my question is, where can i buy this solenoid online? specifically for my cars model. does anyone here also experience the same with mine? thank you!

Hi does A and B solenoid is the same with E ? In ebay is same green color harness of A B solenoid..

hai bro, i have change the input sensor 2 weeks past, the AT alarm still appears during speed 45 t0 50 km/h. The alarm code still the same P0791. the alarm reset sometime by itself after few start.. but i still can drive in D mode smoothly... will planned to change the solenoid..

Where do i need to buy the solenoid? Any website for the part?

Hi there,, Would this kit fit my 2011 Mazda3 2.0L?

I have a 2009 Mazda 5 the problem I have is that: after starting the engine, I have to wait around twenty minutes so that I can roll forward

Would this fit Mazda 2007 m 5? Mines wont run unless car is hot

Hola buenas noches amigo para comentar mi problema,..tengo un mazda 3 automatico 2.0l sedán 2010 me salió el código de falla P0772 selenoide E atascado, hice cambió de los 2 selenoides shift E,D,...y cambió de aceite y filtro y para mi mala suerte lo escaneo y no se corrige la falla P0772 cres q sea la TCM........esperaré tu respuesta salu2...desde México.

Does it matter which solenoid goes into what spot?

Hello i have trouble same you p0773 e MADZA3 solenoid 2011 2.0l what the part number i order on ebay so many dont which one around 30_$40 please let me know please

What year bud?

Los 2 esos que cambiaste son iguales

I’m having a issue where car won’t go in reverse sometimes and it’s hard shifting, but I already sent tcm out for repair with upfix.com and I’m still experiencing the same issues, any idea? Thx