McCulloch Pro Mac 510 Resurrection #1

Рет қаралды 1,927

J.K. McClead

Жыл бұрын

McCulloch Pro Mac 510 Resurrection #1.

Пікірлер: 14

@EightWheelsRollin 3 ай бұрын

Thanks for the vid. I watched your #2 vid first and then this one. Both great vids!

@Kevinthomaswatson Жыл бұрын

I was given a 510 in a box, in pieces, cleaning it now and will rebuild. Thanks for the video, very helpful.

@j.k.mcclead9207 Жыл бұрын

Thank You, glad I could help.

@thankswillie Жыл бұрын

thanks again, another excellent video ,,i'm working on my PM 6 wreck.finished mini 35,,,a 1963 200,electromac(ha),then....next project ugly 300

@titannone7487 6 ай бұрын

Gracias por el video, mi inglés no es bueno, cual era el problema a parte de la suciedad externa?

@Jay_Ira 7 ай бұрын

Thanks for this great video. How do these compare to the 100 series? Are they more reliable than the 100 series? Somebody local to me is selling a pair of these for $50. If they're worth saving I'll buy them from him.

@angrymitch1566 11 ай бұрын

Hey, just picked one up, what are the baseline settings on the carb, can’t quite get it to kick over

@j.k.mcclead9207 11 ай бұрын

Gently turn in both high and low screws until seated, then back both out 1-1/2 turns. It may be a little rich, but for most saws, it's a good starting point.

@angrymitch1566 11 ай бұрын

@@j.k.mcclead9207 got it to fire but can’t get it cold started for the life of me without a little help from some brake clean, ideas where to start, was stored dry for 3 years so I’m thinking diaphragm in the carb

@j.k.mcclead9207 11 ай бұрын

Sounds like the needle isn’t quite sealing, it may be time for a carb rebuild & fuel line.@@angrymitch1566

@alexandreplouffe587 Жыл бұрын

Hi what is the use of the screw that your turning at 26,33 min of the video thanks !

@j.k.mcclead9207 Жыл бұрын

I’m adjusting the flow rate of the automatic oiler. Facing the front of the saw, Counterclockwise increases the amount of oil per pump, clockwise decreases it.

@alexandreplouffe587 Жыл бұрын

Alright thanks and do you know were is the screw to adjust chain tension ?

@j.k.mcclead9207 Жыл бұрын

@@alexandreplouffe587 Looking at the front of the saw, it should be on the clutch cover just to the left of the bar.