how to pull golf adapter and shaft switch

No video

how to pull golf adapter and shaft switch

Рет қаралды 17,341

Күн бұрын

Helping a college golfer from Woodstock Ga. we are removing golf shaft adapters from a Titleist and a Taylormade and installing the golf adapters to allow for a switch of the shafts to better fit the golfer. Watch the video to see the specific needs of the switch.
Join us on Mondays 530 pm for whats in my drawers golf talk.

Пікірлер: 22

@mattrevilock2038 10 ай бұрын

Awesome Content Jim. I am always reminded about how easy it is to watch an expert work at his craft. Great job sharing your talents.

@McGolf 10 ай бұрын

Thanks 👍

@charlesbartholomew2910 10 ай бұрын

Great video, Jim! Thanks for posting this.

@McGolf 10 ай бұрын

You bet

@klhening5222 10 ай бұрын

The Titleist adapter - it has a retaining ring at the top. I like to slide it off and remove the rotating cog so that it isn't in the way when heating the tip to pull it.

@edshepard4035 10 ай бұрын

Thank you Jim... you are awesome.

@felloffmybike1775 10 ай бұрын

I appreciate all the content you put out for the community Jim! Always look forward to the videos. Can you please tell me what you are using to line the edge of your bench? Looks like interlocking rubber matting but the shape isn’t quite the normal “puzzle” shape. Thanks Jim!

@robinmccleery3968 10 ай бұрын

Great video❤ looks easy enough, I’ll leave it to the expert.

@McGolf 10 ай бұрын

@everydaygolfer6483 7 ай бұрын

Nice work Jim.

@helenb2504 10 ай бұрын

Can you do one of these on where why and how to apply lead tape as needed.

@danyabsley Ай бұрын

Would you say a micro torch is necessary or would a butane/propane, even map gas torch be ok?

@chriswalker1957 10 ай бұрын

For a DIYer what epoxy would you recommend? Is it something I’ll have to order or can I find it in stores? I’m sure you’ve talked about it before but not sure what video it would be. This is my first trying to do it myself. Thanks and great content!!

@mizunonick1 3 ай бұрын

Jim, is it necessary to spread epoxy on the inside of the hosel as well as on the shaft tip? and how do you avoid melting the plastic ferrule when removing an adapter?.I have purchased a number of extra ferrules for different manufacturers just in case I get heavy handed with the flame !!!!!

@AndyLaCombe 10 ай бұрын

With the Ventus Red shaft/Titleist driver head - did you remove the green TaylorMade epoxy from the tip? After having a ton of adapters moving during curing, what I do now is I take a small philips screwdriver to push the epoxy plug out while it is warm after removing the old adapter. I hate trying to drill it out afterwards. Without that hole for air to escape, the adapter always moves on me.