Getting back to the sleds! That's what I subscribed for!

back to the Louie i enjoyed watching over the years. Missed all your Canadian references and accent.

Louie you should be stuffing some rags around the connecting rod so when your putting on them circlips and washers that nothing can fall into your crankcase and under your crank and then you'll have to pull your entire crank case apart again, you probably already know this but seen it happen to many times not to say anything lol

That sled is going to have some crazy power when it's done! Great work Louie!

It's about time! I've been waiting to see the rest of this build. Nice job!!

if this is anything like your other builds it should be awesome, hope to see this channel come back to life keep it up louis

I love how clean these motors are. Mint!

Your doing a nice job but buy some 1.5 in Silicon heater hose to slip over the small end of your rods so when your meshing your pump shaft to the crank the rods dont bang the crap out of those new jugs.

what about the boggy indy lite 340? will you ever fix that?

Awesome! Can’t wait to see the 925 elan vids

Quick tip put an extension on your seal driver lol saves your fingers

Hey I dig what you guys are doing keep it up!

The you could have heard a mouse fart in that shop....aside from that I'm excited your working on the elan that sled is the reason I subbed in the beginning....I can't wait to see that thing standing up on end! Also amzoil in my opinion is very good assembly oil it coats well and stayed put. This is only my opinion though I'm sure everyone has there favorite oils and lube to use.

finally snow and no more fucking canams

Leakdown video louie, lets see it brother

This thing would of rocked

I think you’re missing two sleeves for the rear studs that hold the jugs down.

Mega Elan WooHoo!

More Sleds and Snow Dog!!!

How about an Elan 250 Type 247 Mega Monster, Big Bore, Max CR for 91 Octane, Bigger Carb, Tuned Pipe or similar Skidoo Single 277F?

I don't know much about Arctic cat, but shouldn't the water pump shaft seal be inserted with a special seal driver? I know Polaris is pretty picky on them.

What's the tourque value for the cylender pots

Do you still have the turbo rmk

A little heavy on the yamabond!!!

oh yeaa boy😱

Sounds stupid Louie but when your torquing You shouldn’t use extensions they mess with your torque even using a deep socket

Where do you get these ideas?

First comment!

Why wouldn't you be building an Elan based on a ski doo platform with a Rotax!?? This is blasphemous!

Only thing elan is the hood .

Looks like you have a black eye

IF HE SAYS GOOD DAY LADS IN HIS GAY VOICE ILL BLOW MY BRAINS OUT

HIS VOICE ALWAYS PISSES ME OFF