How to install a stylus or hchisel in a Chicago CP9361 Pneumatic Air Scribe.
Пікірлер: 20
@jasonizermathieu83422 ай бұрын
Exellent job thanks for your help.
@fearlessroofer84584 жыл бұрын
Nice little video bud. Only one thing about oiling directly in scribe is oil spits out the end for a few minutes. It's better to oil the hose so it will disperse evenly through scribe. I learned my lesson the hard way by not listening to my paleontologist friends and oiled the scribe directly. It was a good thing I didn't go directly to my trilobites and start prepping. I would have had oil all over the fossils and been ruined.
@meMiner4 жыл бұрын
Thanks for the tip!
@fearlessroofer84584 жыл бұрын
@@meMiner Your welcome
@kassiman53076 жыл бұрын
ONE MORE NICE VIDEO ...!!! KEEP GOING ..
@karimwansa89626 жыл бұрын
Nice I actually like it
@peterpiso73846 жыл бұрын
Cool thanks
@ramonching77725 жыл бұрын
Nice. A few minutes, I am ready to go.
@donnalazar44693 жыл бұрын
Hello. Thank you for this demonstration. Can you please tell me what size air compressor and/or what model are you using?
@meMiner3 жыл бұрын
I use a relatively small compressor. What is important, is it has a small air tank. It fills the tank and I draw my air from that.
@abrara.254311 ай бұрын
What is the size (dimensions) of flat chisel By the way nice video and detail info. Thnx😊
@meMiner11 ай бұрын
No idea. I don't have the specs. I bought mine used.
@tdhoutdoors60746 жыл бұрын
Where do you get your bits from?
@meMiner6 жыл бұрын
I am still using the ones that came with the unit. When they wear out, there are places online that sell good ones. Look at the fossil forums for info on this and recommendations. That is the advice that I will follow. Hope that helps.