Mercedes 190 change parts of ignition system - Distributor cap - Rotor arm - Cables
Пікірлер: 14
@mercedeske Жыл бұрын
Gde si ti, nema te nigde!
@190mex Жыл бұрын
@190mex4 ай бұрын
190mex instagram
@cibukcibuk11955 ай бұрын
Hello, i am a new owner of w201 190E 2.0. 90kw. I started with some maintenance. I replaced the cap of the distributor of the ignition. Before i put the cables out from the cap i marked them (the numbers same as on the ignition cap). Then i replaced them an put to the same position. Then i wanted to measure the electrice resistion of the ignition cables (from cap to spark plugs). I noticed that the numbers on the plastic cover of the cables on the ventil cover dont match with the numbers on the distributor cap. So now i dont know if they have to match or not. Do they? Next idea is, i could make some mistake, or the old distributor cup was install in the opositte direction (if it is possible).... Now i canot try if the engine works because ii sent the coller to be fixed (because of some leaking)... Can you help me? Should the numbers on the plastic cober of the cables match with the numbers on the distributor cup? It means the cable starts on the position for expamle "1" on the plastic cover and ends in number "1" on the ditributor cup? Thank you very much...
@190mex5 ай бұрын
Fire order is 1342 cilinder 1 is below oil cap ignition cable is small to large on distributor cup number 1 is close to srew below if you have a bkack cap cover number is on cover 1342
@olafsoldtimer Жыл бұрын
Nice job, good to use OEM parts. Interesting air filter. Why - to get more power?
@190mex Жыл бұрын
Because the blos system is installed in car runs on gas (LPG) and it is impossible install original original air filter
@asineprestanou52214 ай бұрын
@@190mexit is. I have lpg with original filter
@190mex4 ай бұрын
@@asineprestanou5221 you have Blos mixer or?
@asineprestanou52214 ай бұрын
@@190mex some different Brand, but probably same installation