Mercedes A class Model W176 (2012-2018) rear bumper removal.
Пікірлер: 29
@dankey3346 Жыл бұрын
Thanks for the video, straight to the point on what you need to do. Need more videos like this!
@jackgross3140 Жыл бұрын
I’m glad this helped. Thank you for taking your time out to leave such positive feedback! Much appreciated 🙏
@michalm94610 ай бұрын
Thank you for this great video!
@metty9065 Жыл бұрын
Thank you this helps me a lot to install a hitch 👍
@eastcoastuk97059 ай бұрын
Top vid great simple info thanks for sharing.
@jackgross31409 ай бұрын
Thanks for the feedback! Glad it’s helped out 🙏
@josimargonzalezjaimes79183 ай бұрын
Que medida son los rebites de plástico?
@Marcesko Жыл бұрын
Nice! Thank you! Great camera work and straight to the point.
@jackgross3140 Жыл бұрын
Thank you 🙏
@grupinfractionalorganizatp50035 ай бұрын
hi what device are there yellow after open that plate in the trunk ?
@philmelvin7934 Жыл бұрын
🙏🏻 detailed
@glueh9 ай бұрын
I love you bro ❤
@marcomj8791 Жыл бұрын
I have a 2018 amg line same as yours rear diffuser to replace oem to oem, can it be replaced without removing the bumper?
@jackgross3140 Жыл бұрын
Yes but will be difficult
@ghost_marclv_54538 күн бұрын
Thanks
@teo.junhao11 ай бұрын
can I check what size is the torx screw please?
@jackgross314011 ай бұрын
T40 inside the boot holding the hooks on the trim panel
@teo.junhao11 ай бұрын
@@jackgross3140 thank you!
@jakegrace795 ай бұрын
Great vid ,but just need a bit of info on a tool you use ? We’re at the bit where your in the boot and have popped out the plastic ‘ guard ‘ where the boot latch is . Then you pull out the 2 rubber plugs and have to unscrew a small bolt which is located at the end of a long pin ! Is that a spark plug spanner ? If not , do you know what it’s called and size? Ta !
@jackgross31405 ай бұрын
Hey, it is an extra deep 10mm socket to remove the 10mm nuts. You can tape a couple of deep 10mm sockets together if you don’t have a super deep one
@jakegrace795 ай бұрын
@@jackgross3140 thanks for the info , great tip about taping them together !!!!
@jackgross31405 ай бұрын
@@jakegrace79no worries! They are usually not very tight from the factory, just tightly wrap some tape around the two sockets and it should fit over the threaded bar👌
@jakegrace795 ай бұрын
Daughters had the car 3 years , suddenly noticed wet rear carpets . Bit of searching and found it may be the 2 air vents behind the bumper ( hence your vid being handy !) . Gonna replace them , in your opinion is this likely to be the problem ??
@jackgross31405 ай бұрын
@@jakegrace79 hey thanks for the feedback! 100% the rear vents will be the cause of this as it is a common issue with the 176 A class! Most, if not all of them will have been affected with this problem by now. You can use silicone sealant to seal around them to prevent any water coming in
@the_fearless_explorer1213 Жыл бұрын
What socket did you use pls
@jackgross3140 Жыл бұрын
Snap on extra deep 10mm
@the_fearless_explorer1213 Жыл бұрын
@@jackgross3140 thanks a lot
@Paulpenuk7 ай бұрын
@@jackgross3140do you know the part number please ?