Your welcome I'm glad you found it useful. My internal dialog prevents me from uploading sometimes. With this video I said their has to be somebody out there right now freezing cold and if it helps one person its worth it! I would love to have you as a subscriber. Its free. I have a video on doing the front wheel bearings on this truck not yet uploaded. Germans make great bearings but we (wife) had a little incident a couple winters ago into a small ravine and creek that caused premature failure.

You checked the water right? Simple however I never knew untill I knew about the water heats up from the engine then the thermostat opens which then allows hot water to circulate and flow into the heater core. Heater core is located roughly where the aviators is and is basically a small radiator with a blower that blows through this small radiator (heater core) and into the vents etc. Heater core can become clogged with rust, themstats can rust closed, make sure you have water. ..... ??

You are welcome. Thank you for the comment as well.

The blower fan pushes it into heat position. I use a thick wire to keep it in the cool position. Ran it through a hole in the back of the glove box. However your air-condition issue may be something else. Good place to start maybe. My AC doesn't work right now neither does my wife's. Same car. We added freon to hers a while back helped some but then went away. I thinking they both will need a new ac pump. Check power to your switch the flap, make sure you can hear the pump switching on and off by pressing the switch while listen for the "clunk sound" and seeing if the pulley on pump is engaging. Turning.

@@Mavericksa I'm pretty sure it's holding freon, I put a gauge on it and it read on the lower end (but still in the green), then went off the chart. I think it's bc the compressor is kicking on and off because it's low, not sure. There's something goofy about the ac on these cars. It used to work, then it didn't. But when I switch from cold to hot it makes no sound so I'm pretty sure the blend door actuator isn't working. I will check the fuses too, since that also seems to be an issue...if the front two fans aren't running the ac won't work right.

That's what I have going on right now. Uses one wire from 10g 120v wiring works.

I paid 600$ for this lil truck it had 360000 miles on it pushing 500 now. Runs great day put a transfere case in and coils guess I did do the water pump too. 4x4

@@Mavericksa I paid $1200 but only 108,000 miles, I've watched a lot of videos and they seem great.

Just cold air.