No video

Mercruiser thermostat housing water flow

  Рет қаралды 14,652

MollyTV1

MollyTV1

2 жыл бұрын

Describes the operation of a mercruiser water flow on fresh (raw) water systems
It flows from the impeller to the housing
At the housing it goes to the water or recirculating pump as well as to the risers
There is less flow until the thermostat opens . Water cannot circulate through the block until the thermostat opens. So the incoming water is blown out to the risers. While the water are the recirc pump / block is blocked (dead headed) so which why the pump pressure blows out to the risers.
Once the tstat is opened the hot water in the block then circulated through the thermostat back through the water pump then into the block , there is more flow from impeller to the water pump since the tstat is open and water flows to cool the exhaust
Tstat closed - no flow through block, but flow to risers
Tstat open - flow through block and exhaust
Tstat is always full open 20 f higher than rated . So mine is a 140 , other options are 160
Do not remove the check balls to the risers (not shown) otherwise you may starve the engine of water (think of flow like turning on water faucets in your house with limited water pressure)

Пікірлер: 17
@Paulinthewyld
@Paulinthewyld Жыл бұрын
Dude, thank you. I opened my 5.7 and the thermostat was upside down, spring side facing up. Totally threw me! I’ve had the boat for two years and it ran great with no temp issues. Never knew a thermostat could rub upside down, this explanation really helped - thank you.
@MollyTV1
@MollyTV1 Жыл бұрын
Glad it helped
@kristoffscuba5466
@kristoffscuba5466 Жыл бұрын
Very useful video. I can also confirm that it is the same set up on the 4.3 mercruisers like I have. Like you say when the the thermostat is closed you have most of the raw water coming from the impeller flowing out through the risers then the exhaust. Once the thermostat opens water starts circulating through the block and leaves through the exhaust. If you want to know if your thermostat is open you can grab one of those rear most hoses. They only get warm when the thermostat is open. 👍
@jameshunt8285
@jameshunt8285 Жыл бұрын
Well said, it was very confusing, on a car its simple to understand since its a close system. with the constant water flow / constant water supply, the water has to be pumped out somewhere, the excess water flow when tstat is closed is pushed out the riser (with balls), when the tstat opens, the hot water is then pushed out the exhaust ports. there must be enough water flow restriction to allow the engine heat to warm up the constant flowing water. I changed forn a 165F tstat to a 140 tstat, one thing to note, add 20-25F when the tsats fully open, I tested them both in boiling water and thermal gun. This is also helpful when winterizing your boat, until now, i never knew when the tstat ever opened, i usually looked at the gauge, but that is never a great strategy. Check the hoses going to the exhaust
@scottback3020
@scottback3020 2 жыл бұрын
I’ve been looking into this a bit. I’ve found that somewhere in the mid 90’s they didn’t use the check balls on certain models because they changed the bypass hole diameter. Alpha’s used the check balls and bravos did not because the raw water pump was bigger for the bravo and flows enough water. There is a service bulletin about this.
@dbski06
@dbski06 2 жыл бұрын
Well done my friend.
@larrywalden626
@larrywalden626 Жыл бұрын
I'll have to watch this again because I still didn't understand the routes in how they work lol
@giuseppescavella472
@giuseppescavella472 Ай бұрын
Hi! Thanks for this video! Do you know where i can find a 16413-c thermostat housing in good conditions? Thanks!
@jodmidgley
@jodmidgley 5 ай бұрын
i think you solved my problem. i recently repowered my merc 4.3 alpha 1 gen 1 engines with 350 vortecs. the 350s used to be fuel injected with a bravo pump. i rebuilt the blocks with 4 brl intake manifolds and used the same alpha thermostat housing from my 4.3. Engines ran fine but were "over cooling." Once engines got to temp of 175 i would open it up to plane off, the temp gauge would drop like a stone, slightly climb back up then drop again, but it would never overheat. im under the assumption that the sterndrive waterpump is pushing too much water into the block, thus needing those relief balls so the excess water is released thru the exhaust. sounds possible? im going with that!
@MollyTV1
@MollyTV1 5 ай бұрын
I heard they removed them on later models But the theory is , no balls equal less water flow to the engine = higher temp . Stuck balls = more water flow to the engine. In your case Remove the balls , see what happens
@breezy3564
@breezy3564 Жыл бұрын
I’m in the middle of replacing my thermostat. 1988 Merc 7.4. Same thermostat housing. My exhaust and riser hoses are hooked up opposite of your diagram. Wondering if previous owner hooked up wrong. or does it matter?
@UnicycleIdiot
@UnicycleIdiot Жыл бұрын
They are probably hooked up wrong, but you can check online with diagrams of the hose routing.
@stefanosk2700
@stefanosk2700 Ай бұрын
SOS!! I CANNOT find this part to replace
@MollyTV1
@MollyTV1 Ай бұрын
Which part ?
@stefanosk2700
@stefanosk2700 Ай бұрын
@@MollyTV1 thermostat housing
@samg9286
@samg9286 Жыл бұрын
HI, Thanks for this informative video. I have a mercruiser with alpha one Gen 2 , that was overheating, i replaced the impeller and that solved the problem, but my concern is that the water is coming out of the outboard is cold on one side and hot on the other side with weaker water flow. Does any one know why ? should i be concerned? Thanks in advance for any replies. Sam.
@MollyTV1
@MollyTV1 Жыл бұрын
Sam Sorry I dont know . I’d study the flow diagram. I’d assume the temps should be the same. The only restriction that would vary is either a check ball is missing or one of the risers or hoses are plugged . However a plugged hose won’t give you cool water. A missing ball may give you cool water I’d check some message boards and maybe other boats with same set up to see if it’s normal Best of luck .
Why is my BOATS Engine OVERHEATING? Thermostat Replacement
19:45
Keys Boating Channel
Рет қаралды 18 М.
Marine Exhaust Manifolds. How Do They Work?
12:42
Schneids15
Рет қаралды 328 М.
Pool Bed Prank By My Grandpa 😂 #funny
00:47
SKITS
Рет қаралды 18 МЛН
Jumping off balcony pulls her tooth! 🫣🦷
01:00
Justin Flom
Рет қаралды 35 МЛН
ROLLING DOWN
00:20
Natan por Aí
Рет қаралды 9 МЛН
Smart Sigma Kid #funny #sigma #comedy
00:40
CRAZY GREAPA
Рет қаралды 37 МЛН
Mercruiser Boat Project Cooling Water Flow Check
17:42
Capn Stevo Anything Goes
Рет қаралды 33 М.
Mercury MerCruiser 3.0 thermostat
6:39
Yooper
Рет қаралды 60 М.
Overheating in Marine Inboard Engines
13:27
Mr Lopez
Рет қаралды 2,6 М.
Mercruiser Raw Water Pump Impeller Replacement Tricks
15:36
2stroketurbo
Рет қаралды 14 М.
Mercruiser V8 Water Pump Fix & Test
13:25
Fixit Dan
Рет қаралды 28 М.
Boat Engine Thermostat Replacement - DIY Guide
4:44
FixItWithJake 2
Рет қаралды 2 М.
Thermostat replacement 5.7L Mercruiser
9:22
Sailing Flying Scotsman
Рет қаралды 86 М.
REVIEW: Everything Wrong With A Mercury Mercruiser
15:47
DEBOSS GARAGE
Рет қаралды 225 М.
Pool Bed Prank By My Grandpa 😂 #funny
00:47
SKITS
Рет қаралды 18 МЛН