Be on the lookout for some really cool updates :)

@@TheFeralEngineer That's why I subscribed. :)

You really only need about 2A, i just always buy the big ones because they're only a few bucks more 😆

There's a bug in pncconf on version 2.9 that causes it to crash on the advanced config, unfortunately.

@@TheFeralEngineer I didn't find that anywhere mentioned. Should I report that on Github or is that something known and I was not enough searching?

It's faster and more robust. You'll have much better performance with any mesa card compared to a parallel port

No clue, I just use them.

This is one of them. You can also use a 7i76e, 7i95 or 7i92 with expansion cards

What version of Linux rt kernel are you running?

There's an analog section, similar to the 7i76e, but without the enable and direction pins. You'd have to map those to outputs, i believe

@@TheFeralEngineer Thanks! 2 boards on the way, so it will be interesting, how to make it work.

Did you start at the bare bones videos?

@@TheFeralEngineer Yep

also, when you're doing the pnconf I don't see a discovery option listed

@@gilesclement sounds like I'll have to do a video on installing from buildbot and compile from source 😆

I've been waiting for someone to catch that 🙂😆

@@TheFeralEngineer keep it coming, that was a laugh out loud one for me. Side note, is there anywhere that gives a decent comparison of the different Mesa FPGA cards? I know you’ve discussed it a bit in your older videos and Mesa has a linuxcnc approved product section but I’ve yet to find a decent “this has more outputs, this can run this kind of spindle, this fpga is faster, etc.” list/video

@@drivenba none that I've seen, unfortunately. Just kind of something you pick up along the way. Maybe I'll do a video on it 🤔🤔

@@TheFeralEngineer I’d donate to a patreon for this info.

I am looking at this very board on eusurplus, priced in euros. Why do you think there is an export restriction?