MetalCloak Jeep JL Rubicon Diff Covers and Skid Plates

No video

MetalCloak Jeep JL Rubicon Diff Covers and Skid Plates

Рет қаралды 3,569

Trail Traveler

Күн бұрын

Пікірлер: 15

@merritts3515 6 ай бұрын

Great job! You're inspiring

@dunnoyolo2238 Ай бұрын

Just got mine installed in like 20 minutes or less very simple and really like it.

@tomballard8433 3 жыл бұрын

Great video! I have to wonder if the new skid plate will gather and hold mud and water?

@frankdepaolo3633 19 күн бұрын

It was so hard for me to see you not start the bolts by hand. Having to rethread one of the bolt holes would not be fun!! Other than that, great video!!

@rtisor 4 жыл бұрын

You over filled. The fill bolt on the MC cover is located higher then stock. Need to fill manually unfortunately.

@BXOG_ 4 жыл бұрын

Dang that sucks

@kirbytheap 3 жыл бұрын

That’s the first thing I noticed.

@karlpatton1249 3 жыл бұрын

Correct. Unfortunately it's hard to get a simple answer on how much to put in. My 2020 JT Rubicon just states fill to the drain hole on the stock diff cover. smh

@rtisor 3 жыл бұрын

@@karlpatton1249 1 1/3 quarts in the front, 1 2/3 in the rear. There is a thread somewhere on jlwranglerforums

@karlpatton1249 3 жыл бұрын

@@rtisor thank you!

@blain5827 2 жыл бұрын

Shouldn’t you start finger twisting bolts first, you going end up stripping someday starting off with power tool

@gravis00 4 жыл бұрын

Not for nothing...but you should drive around and then check diff fluid level again.

@TrailTraveler 4 жыл бұрын

Absolutely, always do. I should have mentioned that, thanks for pointing it out.

@williammenken2090 2 жыл бұрын

You used way too much RTV. You only need a thin bead around the cover and only around the inside of the bolt holes. You could wipe around the outside of the cover but, you can’t wipe out the inside. Over 40 years of work at dealerships, you don’t over use sealer

@TrailTraveler 2 жыл бұрын

Thanks for the tip