Ignus99 thank you, I have been looking for another camera also, but it's finding one that doesn't mind getting a bit mucky!

Connor. scott that should be fun! Any reason why you're not going for a v8? I was looking at all the engines you can fit in an MGB but the only problem is the gear boxes

We're were going to put a rover v8 but we could not find one so we bought a tr7 and took the v6 engine and gearbox out of the car, the rest of the car was scrap it was a rot box and bye the way I love watching the series great vids you should check out my channel iv posted some some videos of stationary engine and tractors I will be posting vids on the mgb in the future .....keep up the great work

Rebuild the Past year after

Thanks, Has been quite hard fitting it in between work. My challenge is to have the sills and floor in the next few weeks. Are there any things you would like to see more of?

I'm going to be replacing the dogleg and part of the rear sill in the near future, so that's what interests me. Cutting, welding, and any small pieces you have to fabricate, etc. It's all enjoyable and educational as well. Thanks, David

David B from doing this one, I would recommend doing the full sections as the PO did half with this one and it didn't last very well

Thank you, I just don't want to bore you!

Longer vids with lots of detail are always good. There's too many on YT already that just show the basics, and skip how it actually gets done. And btw, I love how it's coming along - and the quality of workmanship going into it. ☺

D Morgan I don’t believe there was from the factory but it might have been added. I know that they used asbestos for the heat shield by the carbs