MILL PART PROGRAMMING WITH MASTERCAM 2022 (PART TWO)
Рет қаралды 5,454
Күн бұрынWorking through a part using dynamic toolpaths, stock models, creating fixtures, multiple work offsets etc.
@nicholasdegeorgia6831 2 жыл бұрын
Great stuff!
@tmed71 Жыл бұрын
The music!!
@agentsmith7947 Жыл бұрын
Can u make more videos
@cliftonanderson9095 Жыл бұрын
Where can we get the prints for this part to complete this project from scratch, and develop these procedures and techniques to prove out a better understanding ? Thanks in advance ... great stuff ...
@benhess807 Жыл бұрын
Would it be acceptable practice to run a finish profile pass for op 2 without a part loaded and with a -z offset to create clearance for tooling? As mentioned earlier its best to touch off on features of the part rather than the fixture...or does the fixture count as an extension of the part due to the contacts on the holes?
@BrianWickhamMFG Жыл бұрын
The fixture is fine in this case, and no I would just let the finish pass cut into the fixture in this case assuming we are going to be making multiple parts. I like to set zero on the fixture as vs the top of the part as that will be the same as the part height changes and that the fixture will simulate datum A.
@generousey3358 Жыл бұрын
When I click G1 to post the program for milling it doesn’t post anything. Do you know what I’m doing wrong?
@BrianWickhamMFG Жыл бұрын
Do you have the toolpaths selected? Are you using a HLE licence?
BalcevMMA_BOXING
Рет қаралды 22 МЛН
MLC CAD Systems
Рет қаралды 11 М.
Sergio Outdoors
Рет қаралды 66 МЛН
KiKiDo
Рет қаралды 2,2 МЛН
Olivia Family
Рет қаралды 2,6 МЛН