Yes if you want to get a nice 90’ then they work wonders

Hi and thanks, glad you like it. I am working on cad with a friend of mine that is much better at that stuff then I am

@@skidmores.garage Would you share the cad drawing?

Thanks mate, yer I’m still trying to work out the hole KZfaq algorithm stuff for wording to be honest and what I do is quite specified not may ppl look for it

i much prefer front wheel drive in these as they are so light weight and the engine sits over the front wheels so it better to pull the back end round then have the weight in the back and not much weight over the steer wheels, you van make a rear engine one work iv just not had much development input in one

Hi mate I did another video explaining the frame and tube sizing

Thanks mate, to be honest I never measured the hight

Alright, no worries, just had a thought 👍

@@JayHaell if I remember right the bodys are 4” shorter then a steel one if that helps

@@skidmores.garage whats your tube diameter and thickness?

@@FirstLast-tx3yj the main hoop, front legs, dash bar and rear legs are 45mm OD and 2.65mm wall thickness as that’s what it has to be in the blue book and the rest is 38mm OD and 2.65mm wall. You could use 1.5mm wall for this but strength is priority

Hi the floor is 25x25x3mm mate 👍🏻

45mm and 38mm with 2.65mm wall thinkness

@@skidmores.garage thanks

@@ZHIATV no problem, sorry for the late reply