Minibus Camper Conversion Part 15 Truma UltraStore Hot Water Heater Installation

No video

Minibus Camper Conversion Part 15 Truma UltraStore Hot Water Heater Installation

Рет қаралды 10,403

3 жыл бұрын

In part 15 of this Mercedes Minibus camper van conversion, I fit a brand new 10 litre Truma Ultrastore hot water heater in the rear of the minibus campervan conversion (See links below for items used). The Truma Ultra Store 10l hot water heater is fitted by cutting a hole in the side of the vehicle for the combustion cowel to be fitted to ensure all gases are exhausted from the vehicle properly. The Truma Ultrastore 10l hot water heater has the controls for both electric and gas water heating and the controls are mounted at the rear of the vehicle, located close to the Truma Ultra store water heater. The gas and electric lines are fed to the Truma hot water heater and will be connected up when the rest of the electrics and gas are installed.
Consider supporting the channel by becoming a member:
/ @thecampervanbuilder
The following are eBay affiliate links for items used in this video and as an eBay partner, I may be compensated if you choose to make a purchase:
Truma Ultrastore 10 litre water heater:
hwb7h.app.goo....
12mm John Guest Water Fittings:
hwb7h.app.goo....
Shurflo water pump:
hwb7h.app.goo....
Fiamma Accumulator Tank:
hwb7h.app.goo....
Social:
Social:
Visit My New Website The Campervan Builder
www.thecamperv...
Consider Supporting My Channel Via Patreon:
/ thecampervanbuilder
Follow My Facebook Page:
/ thecampervanbuilder
Follow My Instagram Page:
/ thecampervanbuilder
Watch me gaming on Twitch
/ sargentmajormonkey
Do you have a cool campervan you would like featured on the channel? Contact me at
TheCampervanBuilder@hotmail.com

Пікірлер: 41

@500millimeter8 3 ай бұрын

It's the only clip i found that showas how to install the Truma Water Heater. I'm about to do it in my caravan. Thank you very much 👍🏼

@ronrobson4042 3 жыл бұрын

'Relatively' good video 😉 😄

@zenzen9131 3 жыл бұрын

Nice install but personally I would have routed that gas pipe flush down the back wall and then flush across the floor secured with p-clips rather than have it exiting the hole in a big sweeping curve. When the bus is in use people will be throwing all manner of things under the bed and rummaging around trying to retrieve things. As it stands that pipe could easily become detached.

@TheCampervanBuilder 3 жыл бұрын

The pipe cannot become detached as its secured to the heater with compression fitting and the entire heater will be boxed in so the area won't be in use for storage

@chamteleboy 3 жыл бұрын

Hi Thank you for the video. For the gas connection did you have an insert which goes within the pipe which the outside collar squashes the pipe onto to make the seal? Thank you.

@mashabike 2 жыл бұрын

Did you use the gas connector nut that cam with the boiler? It mentions olives in the instructions but no olive is supplied. I was considering an 8mm gas hose with threaded connector.

@neilmoon4766 3 жыл бұрын

Hi mate I've fitted same water heater to my van could you tell me the gas connection size to boiler please ,ps good down to earth videos keep up the good work thanks

@TheCampervanBuilder 3 жыл бұрын

8mm like most caravan/motorhome gas fittings

@keithhaggart5992 2 жыл бұрын

Hi there I’m installing a Trina bge-10 it has a 12 volt connection what would be the fuse rating and and a 240 volt connection what would be the amperage required for circuit breaker on my consumer unit? Thanks

@TheCampervanBuilder 2 жыл бұрын

12v is just the igniter so small fuse, I think 6a trio rcd is enough for 240, but not 100% sure, it was a while ago

@markjaik 2 жыл бұрын

Hi! does the truma b10 comes with the water valves and connectors for the boiler? The 3-piece? Here in the netherlands i have to order it seperatly, but its different from yours in the video. Ours isnt with a click in connecter like it seems to be in your video. Can you just insert the 12mm pipe in the truma connector on the boiler? And if so, do you if if i can order these 3-piece connectors seperatly somehwere?

@davidmcclean8872 3 жыл бұрын

Hi. Might I suggest some form of mesh on the dropout hole, as it looks big enough to allow rodents in.

@andrewgilbride7546 3 жыл бұрын

And mosquitoes!

@mitchellneame6120 Жыл бұрын

The two cables that come out of the heater, what do they attach too..I know one is to connect directly to 240 consumer unit but what is the the other one attached too. I've got 2 control panels one which is self explanatory and plugs straight in the other is open wires?

@TheCampervanBuilder Жыл бұрын

one is 240v, the other is 12v for the igniter

@mitchellneame6120 Жыл бұрын

@@TheCampervanBuilder I thought that 12v power supply connected to the built in wago type connection on the unit. I watched other video where the cable from the unit had a connector plug on it and it looked as if it went to one of the control panels? I thought I had worked it out but cannot get my head round it

@hetvriendelijkespook 3 жыл бұрын

hey man, im following your build for a while, how do you know what diameter the gaspipe must be? did u use a flaring tool?

@TheCampervanBuilder 3 жыл бұрын

almost all common campervan / caravan appliances use 8mm fittings

@madasfish2662 3 жыл бұрын

Hi I'm fitting the same heater do you know what the small brass tube is for it has a taper on one end and knerled on the other

@TheCampervanBuilder 3 жыл бұрын

not sure, can't see any reference to it at all, maybe its a continental fitting?

@jamieday8727 Жыл бұрын

Why did u not use the pump ?

@TheCampervanBuilder Жыл бұрын

This is plumbed from the main water supplied by the pump, not sure what you are referring to, it need to be on a pump to get its water

@jamieday8727 Жыл бұрын

@@TheCampervanBuilder there’s a puMp on the wall and a tank are you. It using them

@TheCampervanBuilder Жыл бұрын

@@jamieday8727 I only have 1 pump and tank that feeds ALL water appliances

@harrydorsett6979 3 жыл бұрын

Hi what size 12v cable will I need to buy

@TheCampervanBuilder 3 жыл бұрын

the 12v is just for the timer and igniter so nothing large, I buy a long reel of 11a cable and use that for most items other than heavy draw appliances

@amacmedia3221 3 жыл бұрын

What size of fuse would you need to run wires from the gas level indicator to the fuse box?

@TheCampervanBuilder 3 жыл бұрын

Nothing big, they are low power

@amacmedia3221 3 жыл бұрын

@@TheCampervanBuilder would 3 amp be ok?

@TheCampervanBuilder 3 жыл бұрын

Should be fine

@amacmedia3221 3 жыл бұрын

@@TheCampervanBuilder much appreciated

@tehdreamer 3 жыл бұрын

Whats the size of the compression nut on the gas connection of the boiler? Mine is missing and the 8mm fitting ones seem too small and dont screw on....

@TheCampervanBuilder 3 жыл бұрын

I think it is 8mm but maybe slightly deeper than a standard compression from screwfix etc, probably just to make you buy their own

@tehdreamer 3 жыл бұрын

@@TheCampervanBuilder Thanks for the reply, I ordered one on ebay, lets hope it fits, but couldnt find any specific Truma spare part that talks about it being different, but it deffinately doesnt take standard 8mm compression nuts, I started to peel the thread of when I forced it on..

@neilmoon4766 3 жыл бұрын

@@tehdreamer hi mate I'm facing same problem did you find out the size ,I messaged the camper van builder then seen your comment thanks in advance

@tehdreamer 3 жыл бұрын

@@neilmoon4766 ye I ordered one from eBay

@neilmoon4766 3 жыл бұрын

@@tehdreamer thanks mate would you still have link or size to order I've been on internet for some time to no avail thanks again