thank you, just replaced mine today, thought season was over, such a simple fix
@fredlingenfelter7871 Жыл бұрын
Nice man. Was looking for a good refresher video since it's been a while since I tore mine apart. Replacing it all tomorrow. Those damn brushes 🙄
@mhcooper84 Жыл бұрын
Not judging the way you do things, but it might be easier in the future if you take a 2x4, c clamp with the socket and a bit of pool lube to press that instead of hammering.
@2AWLS5 күн бұрын
Isn’t the prop side shaft seal on backwards? The seal spring is exposed to the water with it like that…
@marcguerette69085 күн бұрын
Asking the same here
@brooksbouye42452 жыл бұрын
Nice video appreciate for sharing
@Mags120fish12 жыл бұрын
Nice job. Appreciate the content. Have an ultrex so this will come in handy if I need to change the armature. What were the symptoms of the bad armature?
@rocketsurgeon1746 Жыл бұрын
Has anyone found the exact location of water intrusion? Mine is leaking for the third time and I'm done with the dealer
@electriceye3942 Жыл бұрын
good video! I think my Ultrex has water intrusion again so I'm going to tear into and see what's up.
@chuckcunningham2786 Жыл бұрын
What did your ultrex do to make you think it had water damage. My prop has stop spinning.
@electriceye3942 Жыл бұрын
@@chuckcunningham2786 I would step on the go switch and nothing would happen and then it would just turn on. I had some dead spots on the armature from the leakage.
@pinballjunky711726 күн бұрын
@electriceye3942 That is what mine is doing also. I need to find the armature kit. Will you please send me that information.
@rocketsurgeon1746 Жыл бұрын
Nice work
@jeffreyriddle4645 Жыл бұрын
You used a "straight" electrical connector???? I'm doing mine now and I couldnt fit the straight one in. It comes stock with a 90° "f" connector, which I cant find. How did your fit in there??? Also you should torgmque those long bolts at 40" pounds.
@philliplovett31844 ай бұрын
Where did you get the kit?
@pinballjunky711726 күн бұрын
I need to replace my armature also. .i have 36v 112 torque. Did you find the kit?
@MarkGoinesHookedonfishin Жыл бұрын
Where do you get the stabilizer peace goes between the 360 and the trr trolling motor shaft ?