Well done and good health

Glad to have you back really missed you and your videos last comment I made I’d just completed the front chassis engine tie plates and driver side Inner wings made a bit more progress since your last video driver side front and rear floor pans and sills both front and rear doors panels replaced and finally rear chassis member and spring pocket replaced due to install rear inner wheel arch this week. I’m retired so have a great deal of time on my hands you have become an inspiration so please keep doing what your doing Stephen 0:00

i used your heater motor refurb video to rebuild mine, still got to put it back together, but thank you for all your videos on jean, it has helped massively with my resto of lucy. I repainted all my engine and ancillaries, new b and b clutch with stronger springs, then my restorer repainted my engine bay, so clean you could eat your dinner off it! Then the engine and gbox went back in, fitted up a few bits to the engine bay, in the new year, get the rest of it done and get her all running, then its bodywork, respray, refit new chrome, interior and she will be finished!

Great job! A mix of excitement and relief? Nothing better than hearing an engine start up for the first time. Mine was dormant for 20 years!

Great episode! Good to see how it all went back in!

Good to see you back again and I hope 2023 is kinder to your health, and kinder in general, 2022 has been less than ideal.

Happy New year to you . Hope it's a crackin one for you . Been great watching the progress . Mitch

Welcome back Mr Frier, good to see you posting again. Looking forward to seeing Jean going back together. You've put in so much work with all the welding and everything she'll be great. Greetings from a Morris Traveller owner in Somerset. Happy new year.

Great to have you back Friar! Thanks for all the tips :)

I got the extendable bonnet stay too! can't wait to fit it

How you going cobber. Great video. I have just discovered your channel and have binge watched your vids. Please make more 🙏. Awesome content.

Glad to see it going back together!

I completely forgot you had to remove an engine mount when I did it. Urgh, that was frustrating trying to get it in.

Was there a lock tab on front of crank shaft nut to remove before in doing it? John from down under.

Good to see you back, lovely to see Jean back together. I wish you good year, good health and good times. _(I'm Make It Go, this is my new channel, which will feature my own Minor, hopefully very soon)_