Hellu Bro this is verry good video from you I like it.🙂👍 You missed to say check this won out in this video. 🤣 I mss your vedos when you drive with you scooters i will see more of that bro. 👍😎 Have a nice day and take care!

hi man stupid question maybe but what's the dropout size (fork opening) on ti30? i'm willing to upgrade motors in my scooter to the 2800W 60H magnet ones Ti30 has but don't know if Ti30 is also 145-150mm opening and don't wanna spend money to find out it doesn't fit i also have 2 75200 alu pcb (single motor) ready but first wanna build higher voltage and current battery and upgrade motors all together basically, currently still have 75100 alu pcb in it with the 48v battery @ 4kW

Możliwe że zaraz coś wstawię ;)

Hi Pirate, I also have a Ti30 with two Flipsky 75100. controlled via VESC tool. If I give good throttle then both controllers go up to 80 degrees. Do you think that is a reasonable operating temperature or do the controllers get too hot? The temperature drops again quickly, but also goes up very quickly. Where is the temperature measured anyway, at the controller or is the engine temperature measured? What could be done to cool the two controllers appropriately? Thanks for all your advice.

i need cooler for vsett 8 motor

Hi Pirate can you make a Basket support on boyueda, laotie ti30 on the rear spring site. This is awesome for daily pleas Pirate

Can you tell me one truth should I buy it is it a good item is it worth using or not please answer me for sure.

Very nice!

1) a fake YunLi controller came from Boyueda, I don’t want to buy it there anymore, 2) the motor is from the same place, with the same short cut bolts as in the video, from which the motor fell apart at first speed, I hope this video will be useful to their customers though would be in terms of the fact that they will change the stock horror bolts and not get killed on the road, 3) otherwise useless content with the sole purpose of selling something even without the smell of temperature measurement results BEFORE and AFTER installing this plastic, and after the temperature may be even higher than DO, especially when dust and dirt accumulate in the blade. The last card in the layout - we "cooled" one side of the motor. Wonderful! What to do with the other side? )))

useless ^^'