Рет қаралды 390
Demo of a shaft/coupling alignment program that allows the user to make simultaneous moves on multiple shafts (up to 6) and get the best possible overall alignment. The program uses Excel Solver plug in which is already included in recent versions of MS Excel. Primary use for turbine or other industrial alignment.
0:00 : Intro and program setup
3:36 : Entering unit configuration
5:40 : Gathering and entering current coupling alignment data
12:42 : Working with outputs: horizontal and vertical alignment
27:16 : Sample run-through of an alignment
I apologize in advance that it's a bit long winded - feel free to watch at 1.25x speed.
*Note - the program is set up for English measurements. Inches and mils where mils are 1/1000 of an inch, not millimeters