Рет қаралды 171
This week taking another step in making the bow sprit. This time I need to make it a weee bit thinner. Two full inches was disproportionately thick so I had to devise a way to get 1/2" off the thickness without an industrial planer.
Building SHÉ:KON is all about Building DIY Boat Kit in our Back Yard. Ours is a modified TW28, Diesel Powered trawler, from BoatBuilderCentral.com
#shekon #BoatBuilding #DIYBoat #PlywoodBoat #BoatProjects
⚓Building a plywood boat in my backyard: can you do it too?
💥 Subscribe to our Channel here kzfaq.info?su...
EMBRACE the CHALLENGE - ADVENTURE is the REWARD
Rick & Lori M/V SHÉ:KON
Facebook .... / knottybuoyz
Instagram .... / building_she_kon
Resources:
Boat Builder Central YT: @BoatBuilderCentraldotcom
Boat Builder Central: www.boatbuildercentral.com
Trawler TW28 Plans: tinyurl.com/fwx2dbdm
00:00 Introduction
01:35 Getting started
02:39 Speed Zone
02:55 Adjusting Saw
03:28 First Attempt to extend bed
03:49 Thinner Edge Cuts
04:01 Speed Zone
04:38 Step One Finished
05:55 Speed Zone
06:09 Ooops Camera Down
06:32 Making Cubits
06:42 Speed Zone
08:12 Step Two Finished
09:22 Plane it Smooth
11:06 OUttro