I think you used too much of the colored resin too, as stated above. Also, just a couple tips, if you don’t mind. 🙂 I’ve learned that speeding up some of the steps in the bloom process does more damage than good. I used to heat up the resin a little bit…I don’t do that anymore. I let the resin heat up at room temp now. I also don’t spray alcohol on the mold or on top of the resin. I do use my mini torch only a few times and just real quick each time. If you torch too much or use the heat gun too long, the resin becomes thinner therefore the design runs together. I still have some bubbles but honestly I don’t think it matters all that much. Anyway, these are 3 tips that I’ve learned over the past few months and it’s made a huge difference in my blooms! It took me awhile to figure out that blooms require patience. Hope this helps and good luck on the next bloom!! 🌸🌺🌼

I think your idea is fine just way to much resin for the butterfly