My Milwaukee Packout Trailer (Part 2) Tool Tour and Upgrades!!!

Рет қаралды 3,688

Ай бұрын

What’s up guys! In this video I’ll be taking you on a more in depth tour of my Milwaukee Packout Trailer set up. I’ve made some upgrades and I’ll show you most of my tools. Hope to see you guys in the comment section. Like and subscribe for more content!

Пікірлер: 19

@joeypwns 6 күн бұрын

i love this, im a maintenance man for family's commercial properties and i just bought a new trailer, this gave me a lot of ideas thank you!

@ans1020 2 күн бұрын

Working out of a trailer or van is the only way to work effectively and efficiently.

@ligyron2835 Ай бұрын

Also I absolutely agree. Never buy a cordless SDS max. As someone who used a rotary hammer every single work day for 15 years, when you need the big boy gun batteries just become more of a hassle than they are worth. BUT a cordless SDS plus is a godsend for all the small anchors/chipping.

@JeffCdeBaca 22 күн бұрын

What a collection!!!

@ligyron2835 Ай бұрын

I find the pencil sharpener both practical and hilariously goofy at the same time. Good ole lumber pencil and a knife has been the way since before either of us were born😂😅

@ans1020 Ай бұрын

I only like to work with traditional pencils. I don’t know why. I also like a fine point. 😂

@ligyron2835 Ай бұрын

@@ans1020 Oh I keep a little hand sharpener in my “main bag” and I always got regular pencils lying around too. Sometimes the fine point is needed for certain things. That’s why I said “both practical and goofy” because I see the value in it but at the same time you know there’s plenty of times you ‘marked’ with whatever is closest to you. I’ve even just scratched a line in something with whatever nail/screw was in my pocket/pouch in a pinch. 😝

@KevKulcsar Ай бұрын

I feel like you can PPF the solar panel. DIY. It's atleast a little protection for a low cost.

@RTDNECO Ай бұрын

I’ve had good luck with my 18 gauge nailer, not sure which generation you have (gen 2 came out in 2022 I believe). Milwaukee is coming out with an m12 18 gauge brad in a couple of weeks. Might be a good option if your max nail is 1,1/2” and you still use your 15 gauge for heavier applications.

@ligyron2835 Ай бұрын

I personally learned there is a very fine line between neat and “too neat”. I remember field guys I learned from that would waste 20-30 minutes every day wiping every bit of crud off their handtools. Then wondering why I passed them up and became their foreman. Because while you were busy polishing your boots I was busy getting things done. Of course, I’m not a pig either. Take pride in your job and your equipment. I started as a “shop kid” at 13 and one of my responsibilities was repairing all the broken field tools that came back. Learned how to repair pipe threading machines, sawzalls, etc at a young age. And that’s why I got some tools that are 10+ years old and still chugging along like new.