Needle arm stuck, can’t get main axis to 100…machine just floating…this could help

Рет қаралды 15,816

Жыл бұрын

Пікірлер: 21

@charleswoods8157 Жыл бұрын

Bro, thank you so much. I have a different machine brand, but your video solved my issue. On my QHC/Revhon, it’s the screw on the left, and I was able to use included allen wrench by sliding the main shaft all the way to the left. Many thanks!!!

@SheWynNY Жыл бұрын

Thank you so much for your time.. I will definitely try this and wish for the best. I will keep you posted on the results . You are truly appreciated 🤟🏾❤️

@alberta1860 2 ай бұрын

Thanks brother it’s a big help at 2 am can’t call no one and need the job done for morning 👍

@Arniehd 6 ай бұрын

My Ricoma did the same thing, waiting for parts. Since day one I have had trouble with my Ricoma machine breaking down. I am considering trading it in for a different brand, the problem is no one will take a Ricoma as a trade in.

@IAMMEINC Ай бұрын

I hate my machine too it gives me so much problems

@leviteapparel Жыл бұрын

Knowledge for the people more power 🔋 for success.

@viveksharma-wi4nm 8 ай бұрын

Thank you for the information..i managed to get my machine up and running.

@phineeprints9840 8 ай бұрын

You’re welcome

@1hrflyerguy 4 ай бұрын

Thank you sir!!

@animegamesarelife7074 Жыл бұрын

Thanks for this video. Currently trying this. I can get the screw inside to loosen. I'm afraid it will strip or break

@phineeprints9840 Жыл бұрын

If it’s slipping or you can’t get a good visual on it, wait for help, or get a better tool to give more leverage. You may can put it on another needle to see if you get better access to the screw. Crack it just a bit than go back to needle one and fix it. Hope this help and get you back up and running

@LiquidSoul06 Жыл бұрын

Good to know

@stephdownour4674 Жыл бұрын

why does this happen continiously on my machine? please help!

@phineeprints9840 Жыл бұрын

After reset. Make sure you are hitting switch to the top and the light should be red then start. Always try to turn knob first to make the needle arm pop up. Are you getting a lot of no needles?

@Dina-ih5dv Жыл бұрын

I got the wheel stuck I can’t move it, how can I fix it?

@phineeprints9840 Жыл бұрын

Check to make to see if you are 100

@phineeprints9840 Жыл бұрын

100 on side gear

@Dina-ih5dv Жыл бұрын

@@phineeprints9840 yes it’s on 100

@phineeprints9840 Жыл бұрын

Turn the same gear till it lifts the needle arm and the arms align with the other needles. (Machine will no longer be at 100) but you will be able to move the wheel. Move needle to 1 put back at 100 and follow instructions in video

@jalenciabrown2684 Жыл бұрын

Thank you so much this helped with my issue from the other video 🙏🏾