Wow, Hi Ron Sheldon, I'm John Chilton. I needed this video. It's like I'm learning from my future self from 10 years in the past. Great Scott!
@mmoore154510 жыл бұрын
would like to see programming of hand held model
@hlmatthews201110 жыл бұрын
Be cool to hear the tones
@shannonmarler86492 жыл бұрын
Every so often if I flip the lights off (maybe a little quick), buttons 1-6 flash red and switch position 2 flashes yellow and position 3 red. the only way it stops is when the power safety shuts the power down when the car is off for an extended time (overnight). Anyway to restart the system without pulling a fuse or letting it set. And any ideas why it happens in the first place.
@jrg68095 жыл бұрын
Having trouble setting up the traffic arrow functions when using this siren. Basically, i would like to know if the siren itself will control the sequence of the traffic arrow with steady burn LED light pods, or will i need a seperate interface/breakout box which will then send the signal to my LED lights and tell them in which sequence to flash, etc. Thanks for the info.
@razorbeak72955 жыл бұрын
You'll need some sort of interface module, either a breakout box for Soundoff products, or a flasher module to control another brand of lights.
@RealPrimusPalus2 жыл бұрын
Is there a way to deactivate the lights all together when activating the slide switch on the second model? So nothing happens when sliding the switch?
@twisteddamon12022 жыл бұрын
I am not sure that I follow what you are asking. If you mean slide 1 does one thing, and then slide 2 does something else, you are best off using the Independent slide mode. This will make it so each of the three main slide outputs directly correspond to the slide position. It also means that only one can be on at a time. To turn this feature on, press and aux buttons 1 and 4 until slide 2 starts flashing. Then press button 2 followed by radio rebroadcast. Alternatively, you can use the Mode 123 setting on the slide. This slide mode allows 1 and 2 to be independent (like the above), but when slide 3 is on, it turns all three of the slide outputs on. Programming this mode - press and hold 1 and 4 until slide 2 starts flashing. Then press button 3 followed by radio rebroadcast.
@Frederickervin429 Жыл бұрын
Great video! When I turn my slide switch all the way off, my radio shuts off, which is button number four. What could be the cause of this issue?
@twisteddamon1202 Жыл бұрын
The radio shutting off could be from a couple of different issues. I recommend you reach out to our Tech Support team at 800-338-7337 x4. I don't think there is enough information in your comment to suggest a solution. As far as which is button number four? The top most right button (in the group of eight).