New Milling Machine Spindle - Part 3 - Turning The Bearing Housing
Рет қаралды 16,736
Жыл бұрынMachining the bearing housing for the spindle for two 32007 tapered roller bearings. External diameter 80mm, shoulder diameter 85mm, length 145mm.
@stewartfrye 6 ай бұрын
Tape/bandage on finger was priceless, been there.
@alimasoudian1890 5 ай бұрын
Hi Great video I have a question if we have something like this position of bearing then how is the lubrication with grease ?
@motolotnik8213 Жыл бұрын
Hello. Thank you for the great videos. Very good work. I have a question ... how will you later pull the bearing races out of the sockets? Regards
@kvechannel Жыл бұрын
I tried with screwdriver and worked. Is not too tight. But yes i forget to turn a bigger gap for puller. If the if the screwdriver hadn't worked, i would have made a puller with two clamps with sharp edges and a screw inside the two clamps that pushing the clamp edge between the race and housing
@mundodasmaquinas5071 Жыл бұрын
Muito bom seu projeto parabéns !! My Project homemade milling machine my channel
@musicmaneman38 4 ай бұрын
What type of steel is that? I have some 3" 4140cr I want to use.
@kvechannel 4 ай бұрын
Is some kind of carbon steel but i dont know what is.. it has a bluish-gray color and is softer
Garri Creative
Рет қаралды 18 МЛН
M.R. AKPINARLI
Рет қаралды 180 М.
KULI TECHNIQUE
Рет қаралды 166 М.