Using the onboard software for a Nikon Total station
Пікірлер: 8
@MuhammadFahadAli-yz8wg4 жыл бұрын
from where do I can get this simulator???
@flyinlo14744 жыл бұрын
When doing the resection in this demo were prism poles being used? I am learning and trying to understand why the height was zero? If I understood correctly the height is recorded on the resection point, and therefore the height of known points is set to zero?
@sawtatify4 жыл бұрын
In the example, I assume he is shooting reflectorless.
@loveboy51833 ай бұрын
Only RL kiyase set up karega
@rkeducationjobnews1006 Жыл бұрын
How to use corve function
@carlosalbertomartinezmaldo93183 жыл бұрын
Tiene el emulador
@himanshumoon66474 жыл бұрын
in my ts ..no programme is showing..sftware is missed...how can it recover by hard reset..or any other method...pls reply sir.thnqu