Nissan K11 Micra Ga16/GA14 Project Part 3

No video

Nissan K11 Micra Ga16/GA14 Project Part 3 - Finally have an engine!

Рет қаралды 781

44ro.n

Күн бұрын

Part 3 of the project, I finally have an engine for it but it’s a 1.4 not a 1.6 unfortunately. We’ll make do though.

Пікірлер: 9

@brunosimoes6382 2 жыл бұрын

In case you still haven't found that second temp sensor, it's on the intake of the GA! To the left side (timing side) of the engine. The intake has a coolant channel and it sits on there

@44ro.n 2 жыл бұрын

Thanks, yeah I found it not long after filming this video. Got the CG one swapped over now.

@brunosimoes6382 2 жыл бұрын

@@44ro.n no worries! Are you gonna keep the CG ecu or run the GA one?

@44ro.n 2 жыл бұрын

@@brunosimoes6382 i’m going to keep the CG ecu, should all work with the stock ecu and wiring loom. In the future i may turbo the GA so if i do i’d go to nistune i think

@brunosimoes6382 2 жыл бұрын

@@44ro.n Oh, and just remembered, can you share the file for the starter spacer?

@unluckydisclaimer4686 2 жыл бұрын

What car is the engine out of? The cg14s are bullet proof and easy power so I'd like to know more about this

@44ro.n 2 жыл бұрын

This one will likely be out of an Almera. The 1.4 cga3's are good but they've gotten expensive, same with the 1.3 cg13's

@unluckydisclaimer4686 2 жыл бұрын

@@44ro.n is there still an aftermarket for almera engines then?

@44ro.n 2 жыл бұрын

@@unluckydisclaimer4686 definitely not as much available nowadays as there is for the CG's but there's still stuff out there. I'm getting a 4-2-1 manifold for it but from america