Well done boys , the sound coming off that motor gave it away another great job done, take care

Thanks for the tip my motor was hot to touch and making same noise gonna replace motor cheers for the assistants

Really enjoyed the vid Sandy!! Keep up the great work!!

🙂 My wipers are working but is banging on the edge of the windscreen frame which makes loud noise. I replaced the wipers still no difference? Noise is annoying on rainy weathers

This wiper motor don't relé?? El motor del limpiaparabrisas no tiene relé??

Me gustaría tener una solución de vosotros como buenos profesionales... Gracias

Hello Sandy! seems like you are really good on what you do! I wish I could be in the UK to take my van to you... I had an electrical problem with my Van back in december, (a Nissan nv300 x82 1.6 2017). The charging system and front wipers stopped working with a Fault error message on the board. NISSAN fixed the charging system problem by replacing one part (ref 231A03439R) and now I have the alternator charging always at 13.6v but the wipers are still dead (together with some other estrange behaviors like Start&Stop not working and a random electrical error+beep that always goes away after a few seconds). I am desperate as another mechanic tested the wipers motor and it is perfect, fuse is ok. 😮‍💨 An IPDM problem maybe?. Could you please tell me which diagnostic tool can I use to read the IDPM module parameters and DTC errors? I would hate to take my Van again to NISSAN... but I couldn't find anybody else that could fix it. :(

Nissan qahqai j10 marca defecto star/stop, batería perfecta... Que puede ser?

What new motor did you put on it?

well done I have a question I have Nissan qashqai +2 2010 the cruse control not working in proper way after you set the speed suddenly after few minutes it stop working and if you cancel it and re set it never response until you switch off the car then again on , do you have any suggestion please

Hi my friend a solution for these prbleme because I have the same probleme Fuse keep is blocking and when I put a newfuse and make wiper on the block

witch launch tool do you use x-431 pad or what

O fallo en el ordenador