The perfect sort of YT video. I was freaking out on Friday thinking this was gonna be a costly diagnosis and repair. Part cost £16.95 and your temporary fix got me to work on Monday.

This helped me diagnose issue so quickly! top video, bought a new part for £20 and it took about 30 mins for me to fit. The engine light is still on however the car runs fine, will be resetting this using a OBD reader.

Brilliant video. Had loss of power and engine management light come on. Thankfully only 2 mins from home. Saw your video, opened up the bonnet and hey presto could see the hose had broken. Took about 10 mins once I had a replacement hose. Now in search of an OBD reader to reset the engine light. Thanks for saving me £££ not taking it to a garage.

Brilliant, just lost power on the car with red engine management light, this was the first video I saw. Went and checked turbo pipe straightaway and sure enough it's split exactly as in the video! Thanks for the help, I was worried it was something much worse...

I did a full repair today, thanks to your video. Great stuff.

Thanks... Saved my dag 👍. On vacation in Germany. Car "humping" when cold and at low revaluations. Unable to achieve more than 100 kph. Red engine light on. So glad I found your video. Not so worried anymore. Sure vacation will continue after a quick fix 👍👍

worked a treat on my 2012 Qashqai, thanks

Brilliant - job done in 20 mins. Many thanks.

thanks for the vid, collecting part sat to fit, wasn't sure how to remove from the turbo with that type of clip, now I do, cheers

Well done mate, helped me remove and got the old and fit the new part today

Thank you - you're spot on.. just had something similar happen to my qashqai.

Mine was air related but on the return from the intercooler to the throttle body. Taped that up temp' until I can source a new pipe. Split around the expanding mouth that fits over the connecting body pipe. (not a split along the pipe). Made a whistling sound at high revs/high pressure. Was also getting 'some' oil over the throttle body/surrounding area. Bought some silicone self-adhesive tape to do the job for now.

Great video. Thanks for sharing.

Thanks for that, it happened to me now. If it wasn’t for this video I would have been panicking 😂

Great video thanks for your great explanation and quality videos

Great video, clear and too the point! Thankyou!

Life save Anton... Thanks Bro 👍

Really helpful. Thanks

Great video and no faffing about. Ill be looking to see if this is the issue on my daughters car. Thanks for posting.

Superb, thanks for the help,great video, your a gent.

Great video! Thanks a lot! ❤️

Thanks mate worked a treat..

Thanks very much great job

Thanks great video. Hopefully this is the problem with my 2012.

Thanks for the video. Have the same issue but red engine light came on. Have stuck it back but light has come off. Also put in some dpf cleaner.

Good video. This is what happened to mine

Nice one bud worked a treat

Had same issue,looked under hood and yep,cracked pipe. At least I know and can inform garage,cheers mate 👍

Great vid it's really helpful 👍

It really was helpful...thanks much

Thumbs up just for introducing me to Kraken tape 😊

Many thanks.

thanks this was exactly the same fault i had

Top man great video

Liking that kraken tape mate 👍

Cheers for the video. I had the same issue over the weekend. I used epoxy glue to seal it. I notice that there is a bit of a lag between 5th an 6th gear. Will deleting the red engine light reset this.

Great video, its just gone on my dad's car £20 for a new one off amazon

Thank you so much I had the same problem but engine management light is still on after change the hose and not pointing the aero up and down in odo when to change the gear

Perfect.. Ours has just given up the ghost 3hrs into a 4hr drive

Thanks

Theks

Hi just your video on fixing turbo pipe

brill wee video

Omg you have put my mind at ease. Driving home and my car lost power of all days. Christmas day with me and my little girl. Rac had to tow me home. But this is the exact problem they saw under the bonnet. Wish I could sort it myself like everyone else but I'm not that good 😔

Ти си ЦАР ♥️♥️♥️♥️♥️

This was exactly what I was experiencing had me worried once I popped the bonnet and removed Theo cover there was the crack and residue

Thanks, looks better than a new one now, mine has gone too,a ran the car for about 5 miles after I notice the split,and lost all power going up a hill even in first gear it wouldn't go,,I had some super glue and some tape,,but no joy, AA came out and towed me to the garage,15 errors came up, he said a need to get it on a computer!!! So annoying crap cars,

I had this problem, I took it to the garage who put it on the diagnostic machine which said the air flow switch needed replacing , at the time I didn’t know that the turbo pipe had cracked . They replaced the switch,all done very quickly, I went back and picked it up . £250 later , I wasn’t pleased especially after driving away and 5 minutes later the engine management light came on . I took it back where they told me the turbo tube had gone , I looked at it and knew it could be changed easily. The hole time I’m thinking I’ve just been screwed over by £250 . I came home and ordered one from eBay Wednesday at 17:30 , new part turned up at 10:15 Friday ,price £17:50 and free postage . It took less than 15 minutes to change . I wish I’d known about this problem before taking it to the garage

Thanks for this great video. Would this also cause the engine to completely shut down? My engine shuts down, then the Orange engine light comes on. I’ve taken it to Nissan about 4 times now and they can’t seem to find the problem. It’s really dangerous as it often does this randomly and without warning.... appreciate your help!

Hi I have a Nissan qashqai 2015 and it kicking you smoke when you spool the turbo also there is like a grinding noise when you spool the turbo and I right in saying the turbo has gone and how much of a pain is it to replace please and if you have a video on this that may help please let me know and thank you for you time and your videos keep you the good work

Great video. Thanks. I’m hoping this is what’s wrong with my 12 plate Ntec. What is the part called? Many thanks.

Hi Aaron. Thanks for your video. I've got a red engine light on and the intake filter seems ok. What else could be the problem?

Great video, changed this pipe. Does anyone know how to reset the warning light on the display?

My engine light ISN’T on but car seems like it’s on limp mode Hardly any power, seems to get worse if you’re turning at the same time as accelerating (pulling out of a junction) 2nd gear seems to be the worst with Jittering for a couple of seconds. Checked my Turbo pipe and yes it looks worn and as if the seal has gone, a little liquid underneath also. Will have to try this fix

Thank you very much for such a nice video appreciate it . Yesterday i was driving my Nissan Qashqai 2008 suddenly the engine start kind of light noise and the engine and oil light turns on at the same time i drove the car around 80km to my house but the engine had no power after that noise in the morning i checked the engine oil the gage was completely dry i put some Engine oil around 5 litter to which shows the right gage and when i start the engine and drive the car was the same there's no Engine power hardly going to 80km/hr . Could you please tell me about the problem I'll really appreciate it. Thanks in advance

Hey, i know this is a long one but I have a Nissan Sylphy 2006, and it does have a problem with power. First off, i do experience a delayed driving force when i step on the gas especially when the engine is hot and not in motion. This happens more so when a high torque is needed for the vehicle to move either foward or backwards. For instance when i come to a complete stop and i have to go over a bump or ramp of some sort, stepping on the gas wont make it go over immediately as i will have to deeply accelerate for a few seconds..say 7 sec..for it to even start moving. Its movement will be extremely slow until it gains momentum and after which everything works as its supposed to. Whilst all these happens, the rev conter on the dash stays stationery and does not act as though there’s any acceleration at all up until the vehicle moves. It wont rev on neutral too and the ”R” for reverse wont show on the dash board as it goes blank when being reversed. My Mech had to change the throttle sensor, had its transmission control unit replaced and also checked the exhaust system for any leakages but no show. I have constantly stayed dirty on it, moving shop to shop but it seems to prove a headache for everybody. Any help/suggestions will be highly appreciated

Hi Would you be able to make a video of Nissan qashqai turbo faults and how to change it and rebuild it Thanks

I've a 2011 J10 model and it's on its 4th pipe at this stage. First time around, Nissan fixed it and charged me two hundred quid. I soon found out that I could get this pipe online for 25 quid and have done the repair myself since. It's a stupid design flaw that Nissan should have addressed long ago.

Is the turbo pipe visable when u open the hood then? Having issues with mine. Black smoke coming from exhaust I find when I'm taking off or high revving and a slight dip in power. Air filter just been changed and egr valve checked. Dreading it being the turbo

My qashqai has just come up with the red engine mgt ligt, will check and provide feedback. Can I still keep driving the car locally (2-7miles) until the parts/pipe is delivered ?

hi anton, our nissan qashqai broke down today on the road and that pipe as shown in the video was broken. the problem is that we drived in limp mode for a good time and then we heard some weird noice and now the engine goes on only for few seconds and then we hear some cranking noise and it shuts down. do you have any idea what could it be except the pipe? thank you

Quick fix on the go. Surprisingly cheap replacement part of AliExpress was casted out of one piece, nothing to snap apart of sensor 😄

Hi Aaron. I just carried out this fix today. Pipe was split in two same place. Put the new part in. Tightened it all up. Cleared the codes went for a 20-30 min drive in 3rd at high rpm doing 50ish mph. Light came back on read codes again. Getting P1525 - Air Bypass Valve System code? Any idea what this could mean? Cleared it again just to see if it will reappear after a couple cycles. Any idea what that could be as I assumed dpf probably needed a regeneration after the split pipe.

Hi grate video do you know if a update mod was made

Hi do you know where the temperature sensor is on a qashqai j11 please trying to clean the dpf

hi great video and good tips 👍👍😊, im looking to buy a 2007 1.5dci nissan qashqai with 107k miles on it what do you thing , should i buy it or not , what you reccommend please?. thanks

I have a question about something unrelated to your video. Can anyone kindly advise me on how to turn on park lights in a qashqai? There's no broken bulbs but when I put the control lever for park lights they don't work. Fuses are OK in the cabin so I am really desperate to get help. Thanks

Could you make a video how to fix ESP on Nissan Qashqai

Same crack in the same place i had today. I order new plastic part £22 on Amazon Prime. Any ideeas why this happened? Also some oil was spill out everywhere. Is the engine oil right?

Would you recommend the qashqai mk1? have you found it to be reliable?

Thanks for that info. i got a J10 year 2013 and currently having shakes while accelerating on 3rd gear. Can anyone helps?

i would,nt bother getting a new one looks like an easy enough job to do, as long as you take a good steady time to do a cracking job lol, you will be alright after all its just a piece of plastic, makes you wonder why on such parts they made it out of plastic for such a critical part or was it designed to fail for them to make more money. personally i would repair as you said and showed us and resin job done .... and no one is ever going to see it or most part most will never know....

Hi,could u tell me what the tube on the left hand side off the engine is please.

Was black smoke included as well as limp mode??

Where is the fuel cut off switch for these cars or is It done only by diagnostics only ???

p00450bd trouble code for my Nissan. Do you have any idea what that could be ?

Hello, I got a 2008 Nissan Quasqai 2. The EML light is on, despite 3 trips to the mechanic for various tests, my engine does not look like the one in the video so I wondered of you had any advice. MOT due very soon and is going to fail due to the light. If I can get it turned off I am going to sell.

I had this part break so I replaced the part, but the engine light is still on and i still have no power along with a hissing sound on the drivers side. Any clue what is the issue plz.

Can anyone tell me why would i need dpf regeneration after fixing this pipe ? What happend if i dont do dpf regeneration after i fix it ?

Having this problem but intermittent, only happens some times when I fill the tank from empty. Help please

Just done mine, but the red light is still displayed on the dash, have you any idea why. Thanks.

I have red engine light on ,on my nissan qashqai +2 2010...what would be the possible problem

Hi i have the nv200 van having no turbo then eng management light comes on i turn it off and i have boost again when i turn it on could it be same problem ? thanks

I've had this exact fault I've changed the pipe and reset engine management light but the engine still runs flat I'm thinking the turbo might be damaged any suggestions would be appreciated? Thanks.

Thank you, just saved me £800 from the garage.

had same problem, and bought new part off amazon and fitted fine all seems fine but red light still on? should i be worried

What is the actual part called? Just looking on Eurocar parts.

Hi just wondering if anyone could help driving today when red engine light came on also the yellow traction control and anti-skid lights came on engine sounded really rough and lost a lot of power anyone got any ideas?

Hi, I've changed the pipe and had a friend plug the machine in to clear faults. Nothing showing up but still no power. What could this be?

We also go for nissan qashqai 16 dci?

How do I find this on a 2012 automatic.

I had the same problem. But after I replaced the part, now the engine no longer has the power it needed. What could it be?

I changed the part. I now keep getting a p0242 code turbo boost sensor b circuit high sign. Any ideas how I can now resolve this? Thanks

Changed the part and cleared the codes, it's still in limp mode?? Any ideas?

don't you replace the boost pipe with something more stronger as a pose for a like to like pipe

Thats some kraking tape you got there buddy 😬😬

Where can i order this part?

Did I have oil coming out of this part?

I replaced the pipe but i have power loss at 5th and 6th gear and the engine light didnt turn off what should i do ?

was it a 2.0 or 1.5