You are welcome thanks 😊

Thanks for your appreciation. Please like share and subscribe my channel. Thanks

You are welcome thanks 😊

You are welcome thanks 😊

Thank you 😊

I noticed your original pads had the metal back plates. The Bosch ones I’ve got to replace my worn ones don’t have them! Do I need to transfer that plate over from the old pads onto the new ones? Or are the new ones supplied without them because they don’t need them? Thank you

@@CBR-Spikes46 no u don't have to. Different manufacturers do different designs. Good luck 👍

@@diykhan perfect thank you very much. Hopefully the t30 motor bolts play ball and don’t round off 😂

Well done 👏

My pleasure 😊

Thanks dear.

Thanks 😊

Thanks 😊

Did the two torx bolts come out okay?

@@PokeJack185 they were a bit stiff so had to be careful with them but they came out ok

@@lukewade7744 Thanks mate 👍

@@PokeJack185 no problem 👍

You are welcome

Yes it is same on 2019

Yes when u turn it u will see which way to turn to rewind the piston.

This one had two pins. Good luck 👍

No really. It should adjust itself when u engage it and then disengage it few times

Thanks for answer very helpful great helpful videos also please keep them coming….👍

You are always welcome

My pleasure 😊

Ignition off and hand brake off.

Thank you

Rear brakes tend to be on a screw that the hand brake rotated to push the piston out so a "brake rewind tool" is best although I've managed a few with needle nose pliers and turning it by hand front ones just a G clamp pop the old brake pad in and clamp the piston back in tends to be faster just remember to not twist or pull on the flexible brake hose and dont pinch the rubber seal around the piston and you can't really go wrong if your unsure ask for help

Thanks for your support. I work as a mobile mechanic.

Thanks 😊

It might needs a recalibration

Via diagnostic machine

Off

It was off.

How do you take handbrake off and it stays off!! I’ve got kadjar! Be same won’t it!! All same

Yes hopefully its going to be same nissan renault parts.

Did u discount the electric motor.

It could be to do with piston too much Rusty inside

@@diykhan no, i made it using a different tecnique mentio ed in anorher video, but i guess it is better if you to tell people how to disengage the handbrake first.....if you don't do it, it is impossible to remove the caliper

Have you checked the Fuses. Does it make noise when u press the release button.

Have to apply handbrake few times.

Seems like the piston is stuck at the rewind position

There is video on you tube. After replacing brake pads. Flashing lights.its normal. But you need to do something. If find the video I will send you link

On it will damage the motor

Thanks for your response@@diykhan

You can rewind the piston with top level diagnostic machine aswell. You go into the brake pad replacement or service option n thats where it gives you option to rewind or reverse the caliper pistons electronically. Good luck

i unfortunately do have the diagnostic tool so will go with this method@@diykhan

@@marcusg500 ok best wishes

It should be same and I would do one side first then go on to the other.

Thanks DIY Khan

I did clean the grease left on the discs with brake cleaner.

You are welcome thanks 😊