NO JOINTER DO THIS

Рет қаралды 7,840

Күн бұрын

If you do not own a jointer this is an effective way to joint boards.
I have been doing this for months while my jointer was broken and it
works very well and it is consistent. Give it a try. I did not come up with this method, I saw it on Honey Badger Woodworks KZfaq channel so I will give her the credit for sure.

Пікірлер: 20

@serendipitynz 19 күн бұрын

totally unneccesary soundtrack - makes your commentary hard to hear

@Mitchell_G_Stepens 18 күн бұрын

@serendipitynz hey thanks for the comment, I am on the fence about the whole background music thing.

@Woodbuilt-y7v 17 күн бұрын

Agree

@vincentcozza99 20 күн бұрын

I've used this way before I had a jointer!! Definitely works. I thought the same way you did lol if it wasn't going to work. Peace

@Mitchell_G_Stepens 20 күн бұрын

I was surprised on how well it worked. Hey thanks for watching and the comment!

@adamerbrecht7093 3 күн бұрын

It’s more efficient than a sled unless you are starting with a live edge or a badly warped board since this is removing an 1/8” at a time

@billybike57 18 күн бұрын

Outstanding idea, thanks for sharing!

@Mitchell_G_Stepens 18 күн бұрын

@billybike57 thanks for watching

@dougmundie7053 17 күн бұрын

I'm going to try it

@Mitchell_G_Stepens 9 күн бұрын

Awesome, hope it works well for you! Thanks for watching and the comment

@philipdavison4066sawdust 13 күн бұрын

That's how I do mine because I don't have a jointer

@Mitchell_G_Stepens 9 күн бұрын

I find it works very well, Thanks for the comment

@michaelsorensen7567 19 күн бұрын

Any thoughts on full length boards? Lotta crazy people wanting 10' long tables, and don't have a jointer yet, and the lumber supplier does a "straight line" that is, well, insufficient.

@Mitchell_G_Stepens 18 күн бұрын

Never done 10' before, sure it can be done if you can keep the boat tight to the fence.

@woodrowsmith3400 17 күн бұрын

I much prefer to shim out the outfeed side of my router table fence. Takes longer than this method, as you are taking .093-.125" per pass, but all I have is time. I usually take .064".

@Mitchell_G_Stepens 17 күн бұрын

Yep that's a good method, like I said, there are plenty of ways to do it. I don't have a router table, but if I did I would probably do it that way. Thanks for sharing another way to joint boards and thank you for the comment and also the view!

@SavageVoyageur 3 күн бұрын

Yes this is another way to joint. I also personally like my router table for this. It has shims on the outfeed side.