Рет қаралды 1,285
This is the design, soldering and installation of a temporary board for connecting the output pcb and pallet pcb together at the top of the vga system. It’s produced directly from the in-progress vga backplane. In Vga 18 it was nice to connect the board up with some bit’s of breadboard and a bit of strip board but I wanted to make thingsnice and stable before moving onto sprite work.
There was a couple of segments of troubleshooting I cut out of this, I don’t like to feel like I’m hiding anything but it was mostly waggling and swapping wires to find out which ones were loose. It would have been an evening of editing to produce some very boring footage and this is an extras channel video. I also move the 574 I use as a timing stand in for the sprite merge circuit onto a mini breadboard. That way the only breadboards remaining are for the palette.
The image in the thumbnail has some improved wiring, I made up some better sized wires. This should be very neat when the palette pcb replaces those breadboards.
0:00 Introduction
0:40 Design
6:26 Unboxing And Solder
11:44 Install
14:13 Test
14:22 Relocate the sprite merge proxy
15:44 Finish