OWS Test Procedure - BilgMon 448

No video

OWS Test Procedure - BilgMon 448 - Brannstorm

Рет қаралды 21,633

Күн бұрын

MARPOL is one of the main convention for shippinh business
Oily Water Separator as one of the MARPOL equipmeny require routine test and inspection.
the procedures may vary on different companies, but you will get the basic idea.
hope you enjoy the video and having clear guidance of the procedures.
made onboard Ocean Jade on July 2021 at Pacific Ocean

Пікірлер: 17

@nmmunna345 4 ай бұрын

It was a jolly info video. Amazing job

@pratikpaul4753 5 ай бұрын

Very helpful video. ❤

@davidmonro3270 5 ай бұрын

There is an old saying at sea" "keep it simple stupid". The pounding in heavy seas leaves no room for such dainty complicated equipment.

@achellsuez 5 ай бұрын

Totally agree

@katsuragisan1 8 ай бұрын

During pumping out shall i keep open fresh water supply valve to monitor together with sample or only to open sample water and close fresh water.

@achellsuez 8 ай бұрын

If all running smoothly then the FW should be closed during OWS Operation. and as per the manual from this specific unit, FW to be used for flushing before shutting the unit off.

@davidmonro3270 5 ай бұрын

The cost of this machine would be astronomical and you probably need to be a scientist to repair it. I had thirty years going to sea and never saw an oily water separator working correctly. Another engineer, a friend of mine solved the problem using three tanks. Absolutely foolproof. So successful shipbuilders started putting in ships.

@achellsuez 5 ай бұрын

For all the hard-working Engineers in the past in developing this machine, i wish more and more clean sea.

@user-oz5xg7ww8f 11 ай бұрын

very helpful thank U ^^

@achellsuez 11 ай бұрын

You're welcome, bon voyage

@blueprince178 2 жыл бұрын

Nice video. I have a question. After flushing fresh water remain inside ows or discharged by which v/v? I mean Flushing water go where through which v/v?

@achellsuez 2 жыл бұрын

My point of few (for not being an engineer), the FW flushing to be done overboard before shutting the system. The valves will be the same valves to prepare the OWS operation. Otherwise, the FW flushing might go back to the bilge tank.