Pachmayr Grips installed on my two Springfield Armory Garrisons
Рет қаралды 734
Ай бұрынI removed the thin profile grips on both of my Garrisons, replaced the thin bushings and screws, installed standard bushings and screws, and put on old school Pachmayr grips that I have always been a fan of. #springfieldarmory #1911 #Garrison1911
@Everescale 29 күн бұрын
Very nice 🖖
@EchoOscarDelta 29 күн бұрын
Nice and clean looking.
@RogueSarge 29 күн бұрын
Thank you. I’ve always liked the look of these grips on a 1911.
@gabeatv 10 күн бұрын
Look really nice! Could you please share the Amazon link? They have multiple offerings, and it's hard to tell which grips will fit my Garrison. Thank you!
@RogueSarge 10 күн бұрын
Remember, you have to change out the slim bushings on the grip to the standard size bushings or these grips will not fit properly. You will also need the standard grip screws.
@RogueSarge 10 күн бұрын
a.co/d/8QZ2Hpj
@gabeatv 10 күн бұрын
Wonderful. Thank you so much!
@RogueSarge 10 күн бұрын
@@gabeatv you’re welcome! I got replacement bushings, screws and a bushing removal tool from Brownells.
@gabeatv 2 күн бұрын
@@RogueSarge I ended up ordering the screws, bushings, and Challis extractors from Wilson Combat. I was surprised it was slightly cheaper. Installed the new grip a few mins ago. Fits like a glove! I was using skater’s tape for the front strap. This is a much better solution. Didn’t care much for the slim grips either. Can’t wait to take it to the range! Thank you again!
BTG “Buss Them Guns”
Рет қаралды 2,8 М.
Clips & Chill
Рет қаралды 9 МЛН
FTAProtect
Рет қаралды 132 М.
BERETTA9mmUSA
Рет қаралды 3,2 М.
CheZee
Рет қаралды 1,4 МЛН
Hornstromp На Русском
Рет қаралды 1,5 МЛН
DakPlay
Рет қаралды 815 М.