really great to see people teaching these advanced techniques. Ansys documentation is useless for this kind of detail and instruction. Thanks!
@rezaafshar38324 жыл бұрын
Thanks for sharing! nice video!
@MrSmitty19925 ай бұрын
Thanks for the video! How do you view the newly optimized geometry after verifying the design point?
@mercazzo62854 жыл бұрын
Thanks a Lot
@luizortigara83563 жыл бұрын
good night, can I set an angle between two beams on truss as parameter?
@TorleivRH5 жыл бұрын
Hi, nice video. Is it possible to use this parameter optimization for designes/structures assembled in design modeler and not spaceclaim (say a hull of a vessel)?
@garrettjones6675 жыл бұрын
www.ozeninc.com/parameterize-everything-ansys/ This shows a short snippet of how to parameterize in design modeler.