Very nice mark 👍. Yeah that's a great speed controller hobby wing is the best. Looking forward to see stage 3 👊

Enjoying these stage upgrade vids. Thanx! 👍👍

The Amass xt60 from Amazon is a good connector. You’ll find them as a factory soldered on connector on aftermarket ESC. Always had good luck with them. Never a failure. Solder them to alot of batteries and esc’s. Nice thing about them too is the snap on cover for the solder joints. Cleaner looking that heat shrink.

You mentioned a shock set up in the first video but said you would explain and show it in this video,idk .. I was curious what the set up was to help with cornering

Where is the vid for the diff grease upgrade, I cannot find it...I found other vids of yours concerning the Pro4 SC10?

With all the upgrades you did to this sc10, it now cost more than slash ultimate.

what happened to the suspension setup tips you promised?

So how well does/would this truck do against the TLR TEN-SCTE 3.0 (same driver and electronics)? This is a RTR kit Vs like a team car kit but AE/TA has no other options new in the box for a 1/10th scale 4wd SC truck. I understand it might take say like shock upgrades but not trying to build a complete truck part by part and have 2 trucks after I am done.

Just a heads up. Your link goes to a 60A ESC with motor combo. Not the 120A ESC you mention in the video

2s would run cooler????

Is this truck any good at racing or is it only good for bashing? I am very tempted to get this and start racing (don't have budget for anything more expensive).

That esc comes with dean's?