Hello. Your tool hadn't had a problem with speed control or speed 5 or speed 6. You used the orbital function with concrete while you shouldn't. The orbital function opened up the shaft and allowed dust to get in eventually clogging the machine. The mechanism inside isn't in a closed shell but it is wide open, subjectible to saw dust to get in and clog the device. The motor was overloaded causing the burn. You can actually hear the sound it makes , when the dust penetrates the interior
@i.g.unboxidea2 ай бұрын
at minute 10:09 I felt something strange
@user-du6op6qx5sАй бұрын
@i.g.unboxidea probably your model had a manufacturing defect. The o-ring that seals the inside of the tool could be missing. But since you got a new one , all good. I myself was forced to change it 2 times. The main shaft had a lot of play. After 2 tools, I managed to find a proper one without any play.
@Kabodanki26 күн бұрын
ok got it, if I need a new one, just before the warranty ends, I will cut a big block of concrete
@zumbazumba12 ай бұрын
Wshy did it smoke out and stopped working?
@i.g.unboxidea2 ай бұрын
problems with speed 5&6 in my opinion
@markojovanovic94552 ай бұрын
Lie. This one intentionally set the device on fire. Anyone can fire up any device in the world like this in minutes.
@i.g.unboxidea2 ай бұрын
and at 18:30 I smelled burning
@i.g.unboxidea2 ай бұрын
so it's a problem with speed 5&6
@markojovanovic94552 ай бұрын
@@i.g.unboxidea This is a problem on any device that has electronic speed control. Each device requires cooling after a certain period of operation. If the tool gets hot, it must be cooled. The same is the case with De Walt, Bosch and others.
@syyfu__68022 ай бұрын
wow ce dezamagire
@i.g.unboxidea2 ай бұрын
la bine si la rau
@user-tl2ss4uf9h2 ай бұрын
ТОЗИ ЕЛКТРО КОНТРОЛ НА ОБОРОТИТЕ, КОИТО СЕ НАЛОЖИ Е НИЩО РАБОТА 😮 РЕДУКЦИЯТА Е ДРУГА БИРА 🍺 Аз съм доста здрав 🤫 и мога да запаля много машини 😂 ТАКА НЕ СЕ РАБОТИ - ТЕСТВА! Иначе Респект!🍀🇧🇬🍀🥊🍀