Part - 10 | CAN Protocol|Automotive Interview QA|Transmission of Same ID in CAN

Part - 10 | CAN Protocol|Automotive Interview QA|Transmission of Same ID in CAN | Embedded World

Рет қаралды 17,609

4 жыл бұрын

www.eduserve.company
Part 1 to Part 9 Links will be given here !!!
Stay tuned. User your time to learn | Stay Safe @Home

Пікірлер: 16

@sivapraveens9643 Жыл бұрын

Thanks for sharing

@shubhampawar283 2 жыл бұрын

Thank youuu

@sitaram428 3 жыл бұрын

In another video you mentioned, arbitration will be successful but bit error occurs, when two nodes send same CANID from differ nodes at the same time, but here you are telling one of the node will go to bus off. Please clarify.

@Nagendra-kolkonda 11 ай бұрын

How messages are accepting and rejecting in CAN communication step by step??? pls kindly provide the answer brother. How messages are transmitting step by step??? How many filters are there in CAN communication???

@ramanad7223 3 жыл бұрын

Which node will busoff among the two nodes.

@priyankadakepatil7592 4 ай бұрын

CAN H and CAN L

@surendraturai1015 4 жыл бұрын

What happens if we have only one 120 ohm resistor on one end?

@sasikumarreddyanipireddy 4 жыл бұрын

Avoid the signal reflection

@singamsettisaikumar6309 2 жыл бұрын

Here we have to use parllel communication ..to avoid the signal reflection and noise reflection

@seemarv5396 3 жыл бұрын

What happens if a node is alone on the bus and tries to transmit?

@nagendrachamanchula9286 2 жыл бұрын

Communication wont happen There is no node to receive at another end

@penugondaviswanathareddy8379 3 жыл бұрын

What happens when remote frame and data frame with same identifier sending at same time?

@rajeswarimurugan6519 3 жыл бұрын

RTR bit will be dominant in Data frame, so data frame wins the arbitration

@penugondaviswanathareddy8379 3 жыл бұрын

@@rajeswarimurugan6519 thank you for your valuable information

@vini-yan-lan404 4 жыл бұрын

Ecu is connected with canalyzer and ofcourse it's powered up. One CAN message sent via canalyzer(IG block ). What could be the reason if messge is not transmitted? 1. Wrong configuration of periodicity (0)and continuous sent not configured. 2.impedance marching resister might not have connected on the bus. Is ther any other reasons why message not transmitted? 2.

@SivaKumar-ft2xk 3 жыл бұрын

There is no IG block in Canalyzer