you got the tele going again then, looks like she leaks down rather quickly, nice job getting engine in and running sounds lovely
@guymorton2327Ай бұрын
that is a sod of a job to install. Looking good
@FenlandCrusaderАй бұрын
@guymorton2327 thanks, the roller frame made it a lot easier i must say 👍
@matthewshaw5792Ай бұрын
Still better sound than my daf xg ,and I bet does just as good a job as a £250,000 combine today Great workmanship steve
@stevehill4615Ай бұрын
Good ob getting the motor in and running (I'll take the Fiat/Laverdas with the engine behind the grain tank in a nice lift out cradle anytime more than the Massey), pity about the starter, is the bendix pinion stuck in the forward (engaged ) position, as it might be although the solenoid is working the contacts and busbar in the cap are burnt and/or blackened so no current flow (had this on a few machines i've re-comissioned), also with the engine and gearbox mounts if you're going to have to replace them instead of using stud,stud mountings using (of the same diameter & height) threaded socket types with a bolt would make putting the new ones in really easy.
@bobpaterson1845Ай бұрын
Excellent video again 👍 wouldn't be right if all the pieces just fell into place would it 🤔🤣 very nice sounding engine that 💪💪 just a shame about the Bendix never seen one seized up like that before 😕 can you get stop cable or do you just use a piece of piano wire 🤔
@FenlandCrusaderАй бұрын
@bobpaterson1845 thanks bob i made one out of mig wire liner and a length of stainless tie wire and and soldered it to the original pull lever works well
@ashleyvincent4098Ай бұрын
@@FenlandCrusader Great video! Starts and runs really nicely! Can’t wait to see it turning all the machinery. The dipstick and the distributor on the Austin Newage are both on the same side of the engine as yours - must have been very difficult changing and setting the points……..!