www.amusementrental.com/produ...
SETUP & LIGHTING:
1. ATTACH TOP PANEL TO HEATER UNIT (NO TOOLS REQUIRED)
2. INSTALL THE GAS CYLINDER: ATTACH GAS LINE AND PLACE CYLINDER IN HOLDER
3. TURN ON THE VALVE ON THE GAS CYLINDER.
4. PRESS AND TURN THE CONTROL KNOB TO HIGH (MAXIMUM) POSITION (COUNTER-CLOCKWISE 90º). (FIGURE 1)
5. HOLDING DOWN THE CONTROL KNOB, PRESS THE IGNITER BUTTON SEVERAL TIMES UNTIL THE MAIN FLAME IS IGNITED. RELEASE THE CONTROL KNOB 10 SECONDS AFTER THE IGNITION.
6. TURN THE CONTROL KNOB TO LOW (MINIMUM) AND LEAVE IT THERE FOR 5 MINUTES OR MORE BEFORE TURNING THE KNOB TO THE DESIRED TEMPERATURE SETTING. (FIGURE 2)
7. IF THE BURNER FLAME GOES OUT, TURN OFF THE HEATER AND WAIT AT LEAST 5 MINUTES OR MORE TO LET THE GAS DISSIPATE BEFORE RE-LIGHTING TO AVOID GAS EXPLOSION.
REPEAT STEPS 4 TO 6.
SHUT DOWN:
TURN CYLINDER VALVE CLOCKWISE TO OFF AND DISCONNECT REGULATOR WHEN HEATER IS NOT IN USE.