Thank you very much! 👍

@@PBKreviews БРАТ СКОЛЬ СТОИТ ЗАМЕНА ЭКРАНА ? ? ?? ? КАКАЯ ЦЕНА ? ? ?

Marvel of using a flat display now.

lol yeah, it's a life saver vs doing it by hand.

lol yup

Only on apple products because they are greedy capitalists

​PPBKreviews Bro is the S24 70% automation assembly?

lol yeah. Thanks! The screen ran me $240 and the adhesives $50 since I had them shipped from overseas as they were not available here yet. But adhesives should run closer to $20-25 once they are more widely available.

@@PBKreviews Awesome, thanks for the detailed info :)

You're welcome

I do put it with clamps after. Also the heat loosens the adhesive. From what I've been told from a Samsung Tech at the US repair team, they actually put the adhesives in a freezer to keep them more sticky. Then when installing the adhesives, they hold stronger.

Yeah, should always be checked first. I know I checked it but should have mentioned it as well.

👍 Thanks!

Thank you

Thanks!

@@PBKreviews БРАТ СКОЛЬ СТОИТ ЗАМЕНА ЭКРАНА ? ? ?? ? КАКАЯ ЦЕНА ? ? ?

ask them to re apply the back cover. heat will only loosen it and not help. They probably didn't apply it properly or clean off the original adhesive residue before applying the new one.

@@PBKreviews Thanks, it seems exactly what you mentioned. When I press the back cover it becomes flush with the frame but after a short time it goes back outwards. It is very, very minimal but it bothers me.

You're welcome :)

yes original and yes fingerprint sensor works. You may need to factory reset the phone if you have any issues with the sensor not registering

Thanks!

Thanks. Yes, as long as you properly remove the old adhesive, and re apply the original pre cut adhesive/rework kit made for the phone properly, it will retain the water and dust resistance.

👍 thanks

Thanks!

👍

as long as the adhesive is installed properly, yes should retain water resistance

👍

check out rounded.com or mobilesentrix.com both carry original replacement parts and ship international just in case you need parts.

👍

👍

Thank you 👍

Technically, you can remove just the screen without disassembling the rest, but applying a new screen is more difficult since once you apply new adhesive, you have on chance at applying the screen perfectly to the frame while aligning the screen connector to the cable so it snaps on when you apply the screen. If you don't get a good connection or the cable doesn't connect, you will have to pry the screen off again which poses a high chance of damaging the screen. So best way is to remove the back, and the bottom speaker assembly so you can disconnect the flex cable for the screen, then remove the screen, apply the new one and reconnect the flex cable from the back. Then re assemble the back cover etc. If you are referring to the process of removing the old adhesive, and applying the new ones, if you want to maintain the water resistance and dust resistance, then yeah you need to properly apply the adhesive made for the phone to be safe on that end.

Autocorrect in descriptions.

You can get it from www.mobilesentrix.com/replacement-parts/samsung/galaxy-s-series/galaxy-s24-ultra-5g or rounded.com/galaxy-s24-ultra-sm-s928b/ . It's easier if you get the screen with frame combo, since all you have to do is move over your motherboard and parts to the new screen with frame and not worry about attaching the screen to the frame. Rounded.com link has the combo in stock but a bit more pricey. If you are getting the screen without the frame, make sure to get the adhesive for the screen/lcd which is sold separately.

It's not too difficult. If it's not prying off enough to put a pry tool in between the frame and back glass with the suction cup, you need to apply more heat. Once its hot enough should peel off easier.

In this newer model, they mainly sell the screen itself now due to the titanium frame. However they do sell the combo also just harder to find since they do screen only replacements primarily for this model.

hmm I'm not too sure, since it could be a screen issue but can also be an issue with software or the gpu on the phone.

@@PBKreviews I'm fairly convinced it's related to the display (to the individual pixels). Also, if it was a software problem I think it should affect all units, but as far as I've read around, many people claim theirs are perfectly fine.

Nope, requires special tools and machines to get it done.

👍

yep :)

👍

Will do hopefully in a week

@UC20o1OUWGrixnCEE1gQ9 I will buy one of them after seeing your video. Thank you

Thanks!

👍

There is, but its much more hard to find the complete screen with frame assembly even though it is available because samsung is now doing screen only replacements vs the frame combo (I assume because of the higher cost of the titanium frame). So more people will be doing a screen only replacement vs screen with frame combo on the S24 ultra.

well if your screen is broken, your warranty is void. But yep, not for everyone to do.

👍

not sure what you mean

I have looked into it, but there are already a few teardowns of it on KZfaq and I usually don't get enough views on the sony phones to justify purchasing the device. So currently I don't have any plans to do that model but may look into doing the VI when it releases.

I paid $240

Is that direct from Samsung, or 3rd party? ​@@PBKreviews

What's the Link or Web Site to order a replacement screen for the Samsung 24s Ultra? Thank you

Hi, no I'm from US

soon, waiting for it to come in

Hi, there is, its just the first thin layer which is glued to the glass peels off easily when heated from the screen so stays attached to the glass. That's why the glass looks dark in color, or else the glass is clear. If you look at parts of the glass where that thin layer got peeled off you will see its clear. But yeah that's what I thought at first until I looked closer and saw there is a thin layer glued to the glass which just peels off from the screen when prying it off.

Это матрица так расслаивается на две части. Самая верхняя её часть, остаётся на стекле. У Самсунга все Soft OLED дисплеи, сделаны так.

​@@PBKreviews but after getting flat panel we are not able to replace only glass in case we broke it that's how they done intentionally. And ultimately display quality is just downgraded 😢

yup

Yup, there is still screen and frame combos, but its much harder to find since samsung is mainly doing screen only repairs now on the 24 ultra (I assume due to increased cost of the titanium frame).

because of all the software locks, I don't bother much with iphones :)

👍

Thanks!

👍

👍

You can watch the teardown video I did on the S24 Ultra to see that.

I have looked into it, but there are already a few teardowns of it on KZfaq and I usually don't get enough views on the sony phones to justify purchasing the device. So currently I don't have any plans to do that model but may look into doing the VI when it releases.

If it's done correctly, it shouldn't.

Hello

Idk but orange you tube looks hella fine

😂

👍

Maybe you don't know how to listen to the video, where it clearly is stated to apply heat..

👍

yup, most phones will have the copper film behind the screen to transfer heat. In addition to that, there is the vapor chamber (which not all phones will have) and graphite film.