In-Flight Engine Failure: The Drift Down Procedure
Рет қаралды 4,756
Күн бұрынGood Video to watch:
Your Line Training: • Your Line Training, Pr...
Noise Abatement Departure Procedures: • Noise Abatement Depart...
Pilot Job Interview: • Video
-----------------------------------------
==========================================================
Disclaimer:
THIS VIDEO IS FOR ENTERTAINMENT PURPOSES ONLY.
NOT FOR REAL-LIFE OPERATIONS.
PLEASE REFER TO THE OFFICIAL MANUAL AND DOCUMENTATION.
===========================================================
Time Stamps
00:00 Intro
00:10 What is the biggest threat?
00:44 What is the first thing to do?
01:39 How can You apply the Drift Down Procedure?
04:44 Which are the Airbus Drift Down Strategies?
06:20 Conclusions
#driftdown #pilottraining #pilotjob
@George-ow1pc 9 ай бұрын
Thank you Captain
@PILOTCLIMB 9 ай бұрын
You are very welcome!
@peacesalamonlyone 7 ай бұрын
Very clear! Thank you sir.
@PILOTCLIMB 7 ай бұрын
You are very welcome
@anand-menon 9 ай бұрын
Captain Gabrielle, a couple of questions 1. An engine failure produces yaw into the failed engine. Does the yaw damper take care of that or do you have to permanently have to put your foot on the rudder? 2. Half the thrust plus additional drag plus operating an engine at a lower drift down altitude means range is significantly reduced in a single engine failure situation. Isn't this critical during ETOPS?
@PILOTCLIMB 9 ай бұрын
Hello, 1; it depends on the Aircraft, you have a rudder trim that will help you with that. 2: it should be taken into consideration during flight planning and an alternate should be available at all times.
@markcardwell 9 ай бұрын
Thx Cap
@PILOTCLIMB 9 ай бұрын
You are very welcome
@marcioferreira_staritap4 7 ай бұрын
Very good.
@PILOTCLIMB 7 ай бұрын
Thanks for watching!
@AVIATIONSOUNDEXPERT 9 ай бұрын
Hello Gabriele, You said that you make a 45 deg left or right turn. 1) How far do I have to be off my route? 2) If I have reached a certain offtrack distance by flying 45 deg, do I need to fly parallel to the programmed route? 3) Would you use offset function of the FMC/FMGS?
@PILOTCLIMB 9 ай бұрын
Hi, you start the turn for deviation, and then you coordinate with ATC
@coolaamir16 6 ай бұрын
Thank you sir
@migupl 9 ай бұрын
In which mode do you descent? Lvl change with MCT (w/o A/T) should do the trick, right?
@PILOTCLIMB 9 ай бұрын
Correct!
@kidsaviationmentour 9 ай бұрын
If such happened can I use the rudder trim to compensate the yaw and roll, so what about my speed can i maintain VMCA LIMIT
@PILOTCLIMB 9 ай бұрын
It depends on the strategy you want to apply
@daftvader4218 9 ай бұрын
Hi... Is there a page in the FMC you can select giving single engine data ????
@PILOTCLIMB 9 ай бұрын
Yes, EO page...
@Iigor362 9 ай бұрын
Hello. How to set MCT on 737? In FMC?
@PILOTCLIMB 9 ай бұрын
On the N1 Page
@Iigor362 9 ай бұрын
@@PILOTCLIMB and what I have to do with thrust livers after A/T disengage 737?
@waimea56 8 ай бұрын
@@Iigor362 adjust speed in the MCT chevrons...indicated on your N1 display..
PILOTCLIMB
Рет қаралды 19 М.
Captain SQ
Рет қаралды 33 М.