I've decided to return to the channel by creating content around PLC which I've been using at work for the last 5 or so years. If you have any questions, feel free to post them in the comment section; I'll do my best to respond to every cmment. Cheers, Vlad

Today I found one of these on a forgotten box as part of a what it looks like a fleet management equipment. It looks like an abandoned project. I will gut it for another small project I have. Thanks for the intro my friend. It saved me some research!!

These videos saved my bacon (work project involving a MicroLogix 1100, which I'd never used before). Thanks so much!

Thank you for this video. So straight forward and easy yet first video I’ve seen that was truly helpful in getting connected

Good to have your channel back up. I always looked forward to your videos. Thanks Vlad.

Precisely what i was looking for. Good job. Thanks.

Thank you so much… I bought a trainer MB-665 .. Have been having issues. Getting there. Thanks

Thanks alot for the video

I've been working with ladder logic when writing programs to control equipment.

Nice sir

saved me thanks friend

... brilliant explanation ... thanks a million!

Great video mate! Keep them coming. Can you do a video on troubleshooting rotary encoders and servo motors?

Hmm. Never used one of these. I'm a dinosaur. I learned ladder logic on the old Allen Bradley slc150. It used a dos based programming interface and didn't have any sort of internet port. I remember a guy from Allen Bradley coming in and showing us the new system 5 rack mount stuff that could even have a web server on it. Oooo.

Can you run RSLogix Micro Starter lite with Micrologix1100? Or will the processor not be compatible?

How can I get the Rockwell software?

Great content....thanks..

Than you so much for this guide! :D

How does the software send the IP address to the PLC? How exactly does that work?

I purchased a used micrologix 1100 off ebay, I cannot connect or have the unit do anything. I have had no issues with another 1100 unit. All the screen says is: 1763-LEC. BOOT. FRN: 03.05 ready... Can anyone please help?

at around 5:24, when I select Disable Bootp, I checked the PLC, and it flashed a "ip conflict" error on the PLC and at 7:20, when I go into rs linx classic, it shows the Ethernet connections, but it has a red X even though when I go through the control panel, the computer can the PLC as an Ethernet connection. so I'm wondering if there is something I need to do

I'm wondering what to purchase in order to power this appropriately? I'm only programming it for the sake of learning. I will probably attached a few small motors or something in the end.