Tearing down a polished 19mm Polini CP carb and cleaning it to get it ready for an AF18 build.
Пікірлер: 14
@SchleighSimeon2 жыл бұрын
Is there a retainer clip for the carb needle to fasten it down.
@jonathanheiny73005 ай бұрын
What song is this I dig it
@yirkidemaret62787 ай бұрын
What is the tube on the botom for?
@pierrerobert6458 Жыл бұрын
Great video !! What for are these two admissions right next to the choke ? Thank you !😊
@ville5152 Жыл бұрын
oil and vacuum
@arrepuess2 жыл бұрын
Damn, thats extremely thorough cleaning on an already clean carb 😄. Nonetheless good video
@ogKEGGY2 жыл бұрын
I had just polished it, and wanted to be 100% sure I got all of the goo out of it. Thanks! ✌️
@arrepuess2 жыл бұрын
@@ogKEGGY i was watching because i have a zuma with this carb that wont run right no matter what i do. The float isn’t adjustable?
@ogKEGGY2 жыл бұрын
@@arrepuess what is it doing? Not really. You could probably bend the plastic tab, but I doubt they ever get out of adjustment with how they're set up.
@rodixd93412 жыл бұрын
the pilot jet is the same that the pwk's right?
@ogKEGGY2 жыл бұрын
I'd have to double check. I know the mains are though.
@PchelaUbica2 жыл бұрын
Who polished the carb?
@ogKEGGY2 жыл бұрын
I did. I was bored while everything was broken 😂 I didn't notice any difference at all.