Is it solid if kids lean on it??

@raulmartinez7233 yes, the main purpose of this is to keep the kids out. It’s a kids safety fence and engineered as such.

Yes. In some ways it would be a lot easier then drilling. But it might have its own challenges. I’d be more careful of underground pool pipes bc you’ll likely end up pounding them in pretty deep to support the poles well. I’d pound an oversize copper pipe as far as u safely can. Then trim off the top nicely to accept the sleeve and pole. U may want to dig a bit and pour concrete around any of them that aren’t holding strong enough. Def doable but different challenge then drilling into concrete.

Yes. I shorten the last two sections against the fence and the wall and customize them to the link that I wanted.

So let’s look at it this way. The point of the lien is to make the top section of the flexible fence material taught. It looks nicer this way. You don’t have to do this, but I suggest you do. Therefore, I would lean the first and last polls against the structure or the fence that you will be attaching it to. Figure 17 of the user manual talks a little bit more about the purpose of the lean. Also, I think you could get the first and last ones totally wrong and you would still be happy. It is the ones in between that will matter most to you. They also have a phone number if you want to call and ask for their advice which is 561-316-6418 www.dropbox.com/sh/v69vpk6qaf4imu6/AABQ10bglZb0mw_uvX9KtBZ0a/English%20Instructions/Fence%20Instructions?dl=0&preview=1.Pool+Fence+DIY+Install+Guide.pdf&subfolder_nav_tracking=1

Yes. You would refer to the instruction manuals I have listed in the video description. They have advice on how to interconnect to walls, fences, etc. basically you’d use the included hardware and drill small holes the pole or the lenai or self tapping screws. It needs to be very secure so a no doesn’t slip between the two. Like I did in the video to the wood fence.

I can’t remember how long. Pretty long! It will depend on your soil type. www.dropbox.com/sh/v69vpk6qaf4imu6/AABQ10bglZb0mw_uvX9KtBZ0a/English%20Instructions/Fence%20Instructions?dl=0&preview=4.Pool+Fence+DIY+Dirt+Install.pdf&subfolder_nav_tracking=1

We don't get a hard freeze here. But people from all over the USA have this fence. So it would be best to check the FB groups and Amazon reviews to see what people report. Also, can you see if anyone in your town also has them?

No. You can barely get a few fingers under it. Very taught.

It went fine. I took a video closeup or this area. If you email me I can send ya the clip of the plastic sleeves and what it looks like. My email is in the about section of the channel.

@fixitwithjake I looked in your about section, but did not see the email.

In the video description, there should be the user manual for all of the fence components. They explain how to shorten a piece in there. I did it on one piece. Basically you cut it to the size you need with scissors remove three or four Phillips screws on one of the polls sandwich it back in there and put the screws back on. Obviously it’s a bit more complex than this but that’s the basic concept and shortening the length. It’s not a big deal.

The user manual says exactly and it’s controlled by the drilling guide I used in the video. It very deep at all but can’t remember what they recommend. Enough for the sleeve that the pole goes into and that’s it. Any deeper and you risk hitting a pipe or something else so def use a drill Guide to limit the drilling depth. Good question!