Range Rover should be head hunting this man , he knows more than anyone iv ever seen , and iv seen them all as iv been a 1 car owner (L332) for 21 years, 235k miles all done by me

The condition of your antifreeze/coolant is critical too! Here in the Midwest, it easily gets down to -20°C if not much lower, bad coolant can freeze and your engine won't be able to start, or worse could actually crack the engine block.

My number one tip is flush a/c drain tubes, flush all four sun roof drain tubes, clean drain area on sunroof, treat all your rubber seals, lastly treat your windows with a rain x type treatment. These little things make our Land Rovers that much better in winter.

Great video, and looks a very good upgrade to an older car. Well fitted as well. 👍👍👍👍👍

‘11 L322 5.0L V8 HSE owner here from across the pond in America, m8. I copied your bulb installation with the brights with terrific results. Amazing lights, brightest on the road. I look forward to copying the DTRL too. Thnx m8

you are right man, its easy to change the bulb on this one. on my w221 Mercedes s600 on the drivers side its alright to change it if you remove the coolant expansion reservoir, but on the passenger side , because of the ABC fluid reservoir and how tight fit that big ass engine is in there you have to remove the bumper unfortunately.

You’re the man Sam 👌🏾

Great video as always. The tailgates rust from the inside out, so by the time you see it it's usually too late! Might be time for a replacement :)

My truck had the same problem the moment I put the puddle lights, they won't work with both LED in, but works with one in. I put a power cable in to the battery out to the grill that allows me to plug in a trickle charger without opening the hood.

Another very interesting video, Sam … I really enjoyed it 👍😀

Having the same issue with the puddle (approach) lights. Put the old bulbs back in but still no joy (they were working prior to upgrading. Read online that you can force the door control module to do a reset by disconnecting the negative battery terminal for a short while. Going to try that.

Lovely job Sam 👍👍👍👏👏👏⭐️⭐️⭐️⭐️

Great informative and helpful video. 👍👍👍👍❤️

Great information Sam please can you confirm the latest headlight and high beam upgrades you have used , also fog lights and finally the the legs in the boot and the softer lighting in the interior , Thank you Paul

Just fitted new boots to me l322, scorpion verde seems to have been killed off so went with Pirelli Scorpion Zero All Season NCS (Land Rover) 255/50 R20 and have been super impressed.

Can you post a link to the adapter that plugs into the trailer socket for battery charging? I googled but couldn't find it. Thanks!

Just fitted the uppgraded Headlights, dipped and mainbeam , also was an upgrade from the V45 fitted last year to the V55 , Aliexpress delivery was less than two weeks. Thanks again.

Great vid thx, subbed today 👍 A vid on your tailgate bubbling would be great, my L322 has got the same issue. Cheers

Hi Sam, if you're going to replace your light bar up front, you should check out Lazer Lamps UK. They look more in keeping with the svelte and understated front end on the RR. Just my thoughts obviously. Another great video, thanks!

HI,would you have a link for the LED front fog replacement? Thanks

Try a set of Michelin Cross Climate 2. Improved fuel consumption, Mud and Snow rated and decent handling on a dry road. I use them Oct to May.

Hi Sam, great video/content. Thanks for info. Do you know if you can use the same bulbs for the pre facelift L322? I’ve got a 2007 4.4 SC. Thanks

Just had all the rust cut out of the tailgate and rear arches on my L322! Nothing worse than finding a rust bubble or two hiding in plain sight!

Oooh. Bevinsee dipped LED 😊

You seem to be extremely knowledgeable so I’m going to take your brain. I have an 06 Range Rover supercharged with 116k, had 82 when I purchased it 2 years ago. It’s been in the shop because it wouldn’t start. We replaced the battery and alternator. I got it back and 45 minutes later battery lights came on. I took it back and the found the vehicle PWM sense circuit sending 12 volts out of return side of PCM. this fried the alternator that was previously installed. Recommend to replace vehicle PCM along with alternator. So that was done and when they went to get it ready for me to pickup they called and said it wasn’t starting (completely dead) so they needed to run more diagnostic. Have you ever had a situation like this? This car has always been maintained in a garage and has an excellent service history, and I’m the second owner of the vehicle, which is why I had it shipped to my home in the U.S. so I’m a bit perplexed as why this is occurring all of the sudden. Also the garage I us is a specialist garage that only deals with JLR products. Any help would be greatly appreciate it. Thanks and keep up the good work!

Hi Sam, finally subscribed, …another great video thanks. When is the update/video of your remap being released?.

Is that your 130 in the background Sam? Do you use it much over there?

Great channel and content. Just bought a L322 and wanted to ask you if you are still happy with your engine remap? did you also have a egr delete and were there any issues with that ? lastly can you tell me who did your remap ? Thanks again for an informative and in depth overview of the :L322

As always, an excellent video. In your opinion, is there any problem in changing the tire sizes, from 255.55-R19 to 255-60-R19?

Great.. thanks , i have a 09 3.6 ..will the same bulb upgrades work for me.. ?

Has LED technology come to the point of being brighter than an HID in a projector? They never used to be...?

Hello Sam, do you have any flickering issues with any of your LED headlights, dipped or full?

Hi Sam - the D35 Bevinsee (Osram replacements) : does your link land on the correct socket/plug fitting? D2S? Upgraded main high beams to V55's (mahoosive Improvement!) and really would like to have consistency across the front. Wait to hear from you....

Not sure if mentioned but if there are people delaying their coolant leak, and have subsequently filled their car with water, fix the problem asap. That coolant needs gone and replaced with something to withstand lower temps.

Hi Sam, great video, please could you let me know the model number for the LED headlight im struggling to find the correct Bevinse for same car L322 2012 4.4tdv8. Many thanks Jez

Hey sam, did you ever find the rattle from the timing chain you posted about 2 years ago or was it a different problem?

So want those LED bulbs for the headlight, using the link it comes up with loads of options on the connector type, which one doe I need? Cannot remember for the life of me.

AreLED headlights are unlawful in the UK?

Only thing about LED bulbs are they do not melt the snow off of your lenses. Im sticking with the original style bulbs great video though

ADMIT IS WHOS WATCHING THIS DURING THE SUMMER 😂

In the comparison the lights look warmer than your old ones (which I personally prefer), was that just the camera or how it looked IRL? Also, have you considered putting your lightbar on the roofrack? That's what I've done and it works great (IMHO), video here: kzfaq.info/get/bejne/m5eEqLSUqszJdIU.html

Sam - followed your link to the Bevinsee v55 H7's and no matter what supplier i try, it always says they won't fit my 2011 4.4 tdv8 exactly the same model as yours. In the words of Father Dougal... 'I'm hugely confused Ted!"

What the deuce... It's a Galway registration!

Have you guys got any other winter prep tips? 🥶❄️🌨️ Join the brand-new SMAM Facebook group here: facebook.com/groups/871245971394221/?mibextid=uJjRxr

I ordered those bulbs the moment the video ended. Going to replace the lens covers shortly, they're algea on the insides and they look disgraceful.

Is this your Daly driver?

Great videos and tips always Sam! But…. For the love of L322’s please put the original grille back on! The mesh ones look so chavvy! In my opinion of course. Keep up the good work! 👍🏻

Sam, you are still rocking those white letters out tires? You are way better than that! White letters go in, always!