Project CX-3 -- Genuine Mazda Arm Rest install

No video

Project CX-3 -- Genuine Mazda Arm Rest install

Рет қаралды 36,107

east alps custom

Күн бұрын

Пікірлер: 21

@tim_sears 3 жыл бұрын

I dont get why you had to remove the whole console if in the end you just put four holes in the back and screwed it on.

@K-carbon 2 жыл бұрын

If you LOOKS at the instructions and video this guy is doing it correctly

@robdannatt 5 жыл бұрын

Cool tutorial 😎 I've just bought the same arm rest for my car. Have you figured out what the dial at the bottom does / is for?

@squidy932 5 жыл бұрын

I’m the same with u, remove half of ya console to fit an armrest

@gtrigga1 3 жыл бұрын

where did you buy that armrest?

@shhhdontshout 5 жыл бұрын

How much does it cost?

@JMSsssssss 4 жыл бұрын

Im trying to find information on replacing the rear center seatbelt for a 2014 mazda cx3. Is it possible? Looks like its built into the seat.

@mellisachristie9625 5 жыл бұрын

Is that applicable on mazda 2 skyactiv? Since both has the same center console i guess

@carbitch9498 5 жыл бұрын

Yes

@JaimeHammett 6 жыл бұрын

I dont really get the point why you dissasemble all the centre console, you only have to drill the 4 holes and install the metal thing, and then the armrest.

@eastalpscustom 6 жыл бұрын

I installed the center armrest after instructions from Mazda.

@JaimeHammett 6 жыл бұрын

@@eastalpscustom but the point is: do you really need to get off the centre console? If you had to do it again...would you dissasemble the center console or not?

@eastalpscustom 6 жыл бұрын

For me it is easier to disassemble the center console to install the holder for the arm rest. I would disassemble the center console again if I had to install an armrest.

@TheBrewdonkey 5 жыл бұрын

I've been wanting to get one of these for my wife's CX-3. What is your opinion about this arm rest? Everyone happy with it? Or does it feel cheap?

@zilch7116 5 жыл бұрын

TheBrewdonkey cheap and too high, they are flimsy and most of the aftermarket sucks

@charleslastname8587 2 жыл бұрын

Lmao should've showed what it looked like at the end

@carloverdiary6089 3 жыл бұрын

i just want to see, how to remove the console box

@zQQm 5 жыл бұрын

Tried to do with my autoCX-3 2017 but couldn't find how to lift of the whole console as it's connected with front vertical "wing" panels from each side and just could lift 2cm or so. Any ideas?

@569Sniper 5 жыл бұрын

not sure what do you mean? you wanted to lift the center plastic with screen controler or someting else?