PROJECT SEC - EP24: M117 Re-assembly & Distributor Timing

Рет қаралды 5,413

Жыл бұрын

Been a while since I had time to work and put together a video on the SEC project.
Getting close to having this engine project wrapped up, only a couple odds and ends left!

Пікірлер: 15

@krh007 7 ай бұрын

The vac line from the rear of the T/Body (more forward of the other 2 most rear ones that go to the 2 thermo-couplers) which you describe as the long one - goes to the LHS firewall check valve for the charcoal vapour system

@thusithasilva5151 Жыл бұрын

Very helpful and simple . Thank you

@carmel721 6 ай бұрын

Great video! Thank you. Doing this same work on my 1974 450SE

@kalfoogaltmimi5043 11 ай бұрын

Hello, we would like a video on replacing the 16 valve seals

@trevorchilders479 Жыл бұрын

super helpful - thank you. Once she's running, will you check the timing with a light and make adjustments, or is this considered done?

@BGGarage Жыл бұрын

Thanks, glad you found it helpful! Will definitly need to be set with a light still. Right now it is at 0 degrees, heck may not even run at 0 degrees. I have yet to look into the required ignition timing specs, but once its in car and ready to fire I will need to look into this. Progress on this will be a bit slow as I have a few other prjects to knock out here in the next month or two unfortunately.

@Historyinmotion1984 Жыл бұрын

@@BGGarage where are you located? Do you have a shop I would like to speak to you about getting some help on one I just bought.

@BGGarage Жыл бұрын

@@Historyinmotion1984 hello, i am currently in the process of moving to NY. I just work on my own stuff. Happy to help with generic questions.

@rickdunn2041 10 ай бұрын

did you get that transmission sealed up and installed in the car?

@BGGarage 10 ай бұрын

Yes but all i did was input seal, filter and pan seal didnt go further. Cars put back together but no oil pressure right now, been super backlogged on videos

@charlestimmis273 Жыл бұрын

Good job, wrong plugs, use non resistors only...

@BGGarage Жыл бұрын

Thanks for the heads up, got a part number for those?

@alaingillot4718 11 ай бұрын

I used the bosch with resistor for years at the shop with zero issues .

@charlestimmis273 11 ай бұрын

@@alaingillot4718 do you know more than the people who designed this car? If yes then go ahead and use any plugs you want. Eventually your ezl will be affected..